Folnet P
8Pages

FOLNET power controlled by microcontroller

An electroluminescence lamp is basically a light emitting capacitor. It works as a multilayer capacitor with pigment and the isolation as dielectric material. So, connected to a suitable inverter, its load is mainly capacitive. Driving Voltage / Operating Voltage The crystals in the pigment layer start emitting light at about 20VAC. This is the minimum voltage at which the field strength is high enough to excite electrons which cause light emission. The luminance and the achieved brightness is dependent from the amplitude of the driving voltage. An Increasement of the frequency of the...

FOLNET power • The self-heating is minimal. Therefor applications even under thermal sensitive conditions are possible. • EL-lamps have a very good fail-save behaviour. The brightness in operation decreases slowly with the shape of an e-function. There will not be an immediate fail as at bulb-lights • Operation at night and under bad conditions has several advantages compared to conventional light sources: because of the kind of the light, visibility in fog or in smoke is best. • The possible geometric shapes are infinitely including cut outs within the area. The device FOLNET power is...

The setup listed below can be adjusted on the front panel with potentiometers • Amplitude Adjustment of the output voltage infinitely variable from about 0 VAC up to 100 VAC . • Frequency Adjustment of the frequency of the output voltage infinitely variable from 400Hz up to 1000 Hz. • Speed Adjustment of the speed and repetition of the effect • Effect Selection of the effect Nr. 0 J no effect Nr. 1 J Flash Nr. 2 J Blink Nr. 3 J Sine Nr. 4 J Triangle Nr. 5 J Sawtooth Nr. 6 J Sawtooth inverted Nr. 9 J reserved Nr. 7 J Disco Nr. 8 J Steps Nr. 9 J reserviert • Overload LED If the maximum output...

FOLNET power Option Remote Control Input a t t h e b a c k p a n e l ( 1 / 4 " J a c k ) With the help of the remote control feature the amplitude of the output voltage can be controlled with a DC-voltage. The input is separated by optocoupler from mains and output. Control Voltage PLUS Control Voltage Return / Ground Remote Control: Amplitude variable on DC voltage Depending on Model: 0…5V or 0…10V U ctrl = 0 V – Ua Folnet : Umin U ctrl = 5V/10 V – Ua Folnet : 135 VAC 5. Hints The amplitude and the frequency of the output voltage should be adjusted to needs of the application and the...

FOLNET power 6. Hints for Safety and Warning ATTENTION: DISCONNECT MAINS PLUG WHEN CONNECTING EL_LAMP WITH FOLNET ! ATTENTION: THERE IS NO MAINS SEPARATION ! • This device generates dangerous electrical voltages. For this reason the device may be operated and connected by technically skilled and qualified personal only. All manual operations with disconnected mains plug All manual operations on this device, have to be in compliance with all specific national security guidelines. The producer of the device or the installation is responsible for the compliance with limits of EMC .The way of...

e-mail: Info@bmr-gmbh.de Internet: www.bmr-gmbh.de subject of change. edition : 31.01.2012