FOLNET 1 / 2 / 3 FOLNET 1 / 2 / 3 oef controlled by microcontroller

An electroluminescence lamp is basically a light emitting capacitor. It works as a multilayer capacitor with pigment and the isolation as dielectric material. So, connected to a suitable inverter, its load is mainly capacitive. Driving Voltage / Operating Voltage The crystals in the pigment layer start emitting light at about 20VAC. This is the minimum voltage at which the field strength is high enough to excite electrons which cause light emission. The luminance and the achieved brightness is dependent from the amplitude of the driving voltage. An Increasement of the frequency of the driving...

• The self-heating is minimal. Therefor applications even under thermal sensitive conditions are possible. • EL-lamps have a very good fail-save behaviour. The brightness in operation decreases slowly with the shape of an e-function. There will not be an immediate fail as at bulb-lights • Operation at night and under bad conditions has several advantages compared to conventional light sources: because of the kind of the light, visibility in fog or in smoke is best. • The possible geometric shapes are infinitely including cut outs within the area. The devices of FOLNET series are designed to operate...

4. Functions and Operating Controls The setup listed below can be adjusted on the front panel with potentiometers • Amplitude Adjustment of the output voltage infinitely variable from about 0 VAC up to 100 VAC . • Frequency Adjustment of the frequency of the output voltage infinitely variable from 400Hz up to 1000 Hz. • Speed (n.a on oef) Adjustment of the speed and repetition of the effect • Effect (n.a. on oef) Selection of the effect Nr. 0 J no effect Nr. 1 J Flash Nr. 2 J Blink Nr. 3 J Sine Nr. 4 J Triangle Nr. 5 J Sawtooth Nr. 6 J Sawtooth inverted Nr. 7 J reserved Nr. 8 J reserved Nr....

5. Hints The amplitude and the frequency of the output voltage should be adjusted to needs of the application and the specification of the el-foil carefully. Because the lifetime of the el-foil is directly dependent of these parameters. Because of voltage and frequency being too high, lifetime is reduced. TIP Make a setup only to the minimum required needs. By this the lifetime of the el-foil is enlarged. ATTENTION , HIGH VOLTAGE This device has no mains separation! The output terminals are connected to mains are not protected again earth-shortage! When operating in test applications or with...

Hints for Safety and Warning ATTENTION: CONECTION OF THE EL_FOIL WITH FOLNET ONLY WITH DISCONNECTED MAINS PLUG ! ATTENTION: THERE IS NO MAINS SEPARATION ! • This device generates dangerous electrical voltages. For this reason the device may be operated and connected by technically skilled and qualified personal only. All manual operations with disconnected mains plug All manual operations on this device, have to be in compliance with all specific national security guidelines. The producer of the device or the installation is responsible for the compliance with limits of EMC .The way of connection...

e-mail: [email protected] Internet: www.bmr-gmbh.de subject of change. edition : 31.01.2012