MDA16-4i
4Pages

MDA16-4iD/A Converter Module for PCI-BASEII, PCIe-BASE Assemble Measurement Card. Control. Analog. For optimum customization to a measurement application, the PCI/PCIe cards from BMC Messsysteme GmbH can be supplemented with various modules. The short latency of the PCI/PCIe interface makes the MDA16-4i module especially attractive for controlling tasks. Function Generator. 4 Analog Outputs. 16 Bit. ±10V. The MDA16-4i precisely emits analog signals with 16-bit resolution in the ±10V range. They are available at the 37-pin D-Sub female connector of the PCI/PCIe card. 4 analog outputs are provided. Clearly Safe. The galvanic isolation of the analog outputs from the PC ground provides interference-free operation and protects DAQ system and PC against high potentials. The MDA16-4i features a function generator, which outputs various signals (sine wave, rectangle, or ramp function). Signal amplitude (± 10 V) and frequency (max. 100kHz) are programmable via software. Modularity. Individuality. Flexibility. A great variety of analog input modules, analog output modules or CAN modules is available to equip the PCI/PCIe base board for a measurement application. The combination of the modules in the two card slots creates individual solutions. ► www.bmcm.de bavarian measurement company munich

Installation on the PCI-BASEII, PCIe-BASE The MDA16-4i module can be integrated on any slot of the PCIBASEII, PCIe-BASE or older versions. Make sure the plugs and sockets fit together exactly. If using both an MADDA and an MDA16-4i module, the best solution is to plug the MADDA on slot M1 and the output module on slot M2. In this way, all analog inputs and outputs are available at the D-Sub 37 female connector of the PCI/PCIe card. The channels of the module on slot M2 can be accessed at the internal pin connectors K3, K4 of the DAQ card. They can be led out of the PC to a slot bracket with...

3 Pin Assignment of the MDA16-4i with the PCI/PCIe Card The following table shows which pins are used for the connection of the analog outputs. The channels of the module on the first slot are accessible at the 37-pin D-Sub female of the DAQ card. The connections of the module on slot 2 can be led through to an additional 37-pin D-Sub female by means of the add-on cable ZUKA16. MODULE SLOT Ml OUTPUT MODULE MODULE SLOT M2 assignment changes if analog channels of the 2nd slot are led through to the D-Sub 37 of the PCI/PCIe data acquisition card

4 Important Notes for Using the MDA16-4i • The module is only suitable for extra-low voltages - please observe the relevant regulations! It must only be used in closed PC housings (for reasons relating to EMC). • All accessible pins are electrostatic sensitive devices. Provide for a grounded conductive work place. • Only use non-solvent detergents for cleaning. The product is designed to be maintenance-free. • The product must not be used for safety-relevant tasks. With the use of the product, the customer becomes manufacturer by law and is therefore fully responsible for the proper...