Catalogs >
Binks >
AX200L AIR MOTOR ASSEMBLIES

AX200L AIR MOTOR ASSEMBLIES
10Pages

Catalog excerpts

FLU/O TECHPJOI-OGI&S

EN In this part sheet, the words WARNING, CAUTION and NOTE are used to emphasize important safety information as follows: Hazards or unsafe practices which could result in severe personal injury, death or substantial property damage. ! CAUTION Hazards or unsafe practices which could result in minor personal injury, product or property damage. Important installation, operation or maintenance information. Read the following warnings before using this equipment. READ THE MANUAL Before operating finishing equipment, read and understand all safety, operation and maintenance information provided...

Open the catalog to page 2

MAINTENANCE INSPECTION Check for general air leakage and correct motor operation. Perform a pump stall test to ensure correct operation. Perform a stall test on the pump assembly. If air is escaping through exhaust, check air motor piston seal and QEV piston, replace as required. Replace air piston seal. 12 to 36 Months (Typically 10 million pump cycles, dependant on air quality) Replace motor rod cartridge assembly. Replace poppet assemblies. Inspect and replace if required: Main valve assembly parts Order a 250649 Valve repair kit. TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE Switch/interchange...

Open the catalog to page 3

ilWARNING Item 29 should not be removed or modified in any way. It is necessary for safe operation of the air motor. Operating the air motor beyond its maximum air inlet pressure may result in a catastrophic failure of downstream components, and injury. Parts are included in 250703 Seal kit. A Parts are included in 250702 Cylinder seal kit. Parts are included in 250649 Valve repair kit. Parts are included in 250701 Hardware kit. j" Parts are included in 250651 Exhaust seal kit. Recommended grease p/n: AGMD-010

Open the catalog to page 4

• Parts are included in 250703 Seal kit. ▲ Parts are included in 250702 Cylinder seal kit. ■ Parts are included in 250649 Valve repair kit. ◊ Parts are included in 250701 Hardware kit. t Parts are included in 250651 Exhaust seal kit. Recommended grease p/n: AGMD-010 Item 21 is also contained within item 20, 193806. Items 30 - 39 are contained within item 27, 0115010471. NOTE See page 9 for kits details.

Open the catalog to page 5

MAINTENANCE SYMBOLS: EN AX200L AIR MOTOR ASSEMBLIES – MAINTENANCE

Open the catalog to page 6

EN AX200L AIR MOTOR ASSEMBLIES – MAINTENANCE 5 13 MAINTENANCE SYMBOLS: # #

Open the catalog to page 7

AX200L AIR MOTOR ASSEMBLIES - MAINTENANCE DANGER |^OCaution_ Take care when handling the magnets (35). Avoid getting magnets in close proximity to each other. Injury or damage to magnets may result. MAINTENANCE SYMBOLS: @ = ITEM NUMBER NOTE Spool and sleeve assembly (38) is a matched set and cannot be interchanged with other spool and sleeve assemblies. : MAINTENANCE ORDER Reverse for assembly See Caution above ■■ GREASE P/N: AGMD-010

Open the catalog to page 8

EN WARRANTY POLICY Binks products are covered by Carlisle Fluid Technologies one year materials and workmanship limited warranty. The use of any parts or accessories, from a source other than Carlisle Fluid Technologies, will void all warranties. For specific warranty information please contact the closest Carlisle Fluid Technologies location listed below. Carlisle Fluid Technologies reserves the right to modify equipment specifications without prior notice. DeVilbiss®, Ransburg®, ms®, BGK®, and Binks® are registered trademarks of Carlisle Fluid Technologies, Inc. ©2018 Carlisle Fluid...

Open the catalog to page 10