Catalogs >
BIJUR DELIMON INTERNATIONAL >
HIP-P Lubricator

HIP-P Lubricator
3Pages

Catalog excerpts

BIJUR REUNION INTERNATIONAL General Lubricator includes a spring return piston pump and is operated by pulling a lever which raises a piston and compresses a spring, discharging oil into the system. Discharge volume and pressure are independent of oil viscosity. Operation Lubricator includes a spring return piston pump in a plastic reservoir. Pulling up slowly on the tee-handle to the stop fills the cylinder with a predetermined volume of oil. Upon release, spring pressure discharges the oil into the system and returns the handle to the original position. Lubricator must be operated at intervals recommended by machine manufacturer. Technical Data Reservoir Capacity 475cc (1 pint) Lubricator Inlet Filter 40 micron particle separation Discharge Pressure 30 psi average Factory Discharge Setting 15cc Piston Stroke Setting 1/2 to 1-1/8" Discharge Volume Per Stroke 5 to 15cc Viscosity range 100 to 10,000 SSU at operating temperature Notes Regarding Use 1. Lubricator inlet filter should be inspected periodically and cleaned/replaced as required. To install replacement, disconnect discharge tubing and remove cylinder cap. 2. Discharge pressure will decrease as discharge volume decreases and the number of meter units in the system increases. System & Limitations Use meter units type F. Total system flow (0) limitation is given in the table below. BIJUR DELIMON INTERNATIONAL (919) 465 4448 LOCAL (800) 631 0168 TOLL-FREE (919) 465 0516 FAX WWW.BIJURDELIMON.COM 2100 Gateway Centre Blvd., Suite 109 Morrisville, NC 27560

Open the catalog to page 1

Startup Instructions Use clean oil only of the type and viscosity Fill reservoir; operate lubricator until oil flows freely at all bearings. recommended by machine manufacturer. |attehtion| Maintenance Filter Replacement A filter at pump inlet protects the lubricating system and should be inspected every six months. If not clean, replace. To remove filter, pry out snap ring with screwdriver and remove filter disc and screens. To re-install, insert in the following order: filter disc support (coarse screen), filter disc screen (fine screen), filter disc, filter clamp ring and filter snap...

Open the catalog to page 2

BIJUR REUNION INTERNATIONAL Measurements shown in inches. BIJUR DELIMON INTERNATIONAL (919) 465 4448 LOCAL (800) 631 0168 TOLL-FREE (919) 465 0516 FAX WWW.BIJURDELIMON.COM 2100 Gateway Centre Blvd., Suite 109 Morrisville, NC 27560

Open the catalog to page 3

HIP-P Lubricator 3Pages

Catalog excerpts

All BIJUR DELIMON INTERNATIONAL catalogs and technical brochures

HIP-P Lubricator
3Pages