AeroFlow Lubricator Injector Systems, Fluid Grease General AeroFlow Lubricators are pneumatically actuated piston pumps designed for use with single line parallel injector systems. These lubricators are normally connected to the compressed air supply found on the machinery or vehicle being lubricated. Cycle times are controlled via a remote timer/ controller or an air actuated brake counter. When using the remote timer/controller, the lubricator’s air supply is controlled by a 3/2-way electric solenoid valve. AeroFlow Lubricators come complete with a single acting piston pump, check valves and an impact-resistant clear reservoir for visually monitoring grease levels. Application Typical applications for AeroFlow Lubricators range from mobile transport vehicles and trailers to small off-road construction equipment. This economical lubricator is also suitable for industrial applications, including, but not limited to: packaging, food processing and plastics machinery where a compressed air supply is available. Refer to the following datasheets: + Datasheet #35549: GXL Injectors & Manifolds + Datasheet #35744: Fill Pumps + Datasheet #35550: Brake Counter Air introduced to the lubricator’s air inlet cylinder forces the main piston upward, applying pressure to the grease stored in chamber. The pressurized chamber forces a apper valve against its seat. The suction channel to the reservoir is thereby closed. Grease is discharged from the chamber through an outlet check valve to the main line of the system and onto a network of grease injectors. Pressure at the return valve prevents the main line from venting through the return channel. + Datasheet #46911: SMDC Controller Once optimum pressure is obtained via a timed setting or pressure switch detection, air is exhausted from the air inlet cylinder allowing the spring to return the main piston. At this time the apper valve is released and grease is drawn back into the discharge chamber from the reservoir. The main line is vented through the return valve allowing the injectors to reset, ready for the next discharge cycle. Grease Chamber Follower Return Valve Suction Channel Outlet check Valve Flapper Valve Strainer (inside fill conn.) Chamber Main Air Piston Air Inlet WWW.BIJURDELIMON.COM 2100 Gateway Centre Blvd., Suite 109 Morrisville, NC 27560

Economical and simple design allows for trouble-free operation Lightweight lubricator is ideally suitable for on-road transport vehicles Spring loaded reservoir follower provides for an air free supply of grease to the pump Quick coupling at base of reservoir facilitates easy relling of reservoir System Design Verication Follow instructions below to verify that lubricator discharge meets system requirements: 1. Calculate the total discharge volume, in cubic centimeters, of injectors in the system (see Datasheet #35549: GXL Injectors and Manifolds). Technical Data Reservoir Capacity Maximum Inlet...

Service Parts 2 liter version shown 4 liter version shown below: Strainer (not shown, inside ll connector) 53117 BIJUR DELIMON INTERNATIONAL WWW.BIJURDELIMON.COM 2100 Gateway Centre Blvd., Suite 109 Morrisville, NC 27560

Measurements shown in millimeters. Dimensional Schematics 2 liter reservoir version shown. IN FRONT: 1/4" NPT GREASE OUTLET 45±0.2 Reservoir Capacity BIJUR DELIMON INTERNATIONAL