| PRODUCT SPEC SHEET Bulk Bag Loader • A three-layered filling head featuring a stainless steel core fully encased in Seeflex ether-based urethane. • Includes external air fitting that plugs into an 8mm pneumatic air line to inflate super strong & flexible outer layer. • Features a built-in pressure-relief valve (set to 6psi) to avoid over-inflation. • Top of loader simply snaps into a BFM® fitting spigot and features a fully encapsuIated stainless steel ring to support lower end. PHYSICAL PROPERTIES Surface Finish Inner Wall Thickness (+/- 10%) Operating Temp Range Ultimate Elongation (%) • Inflates in seconds and seals tight on the neck of bulk bag, eliminating product leaks. Surface Resistivity (Ohms) • Much safer for workers hands as there are no pinch points. • Can be used on bulk bags with or without plastic liners. Standard BFM® fitting snap-fit cuff Stainless steel tube encased in layers of Seeflex AVAILABLE SIZES: • NB: Pneumatic air-line is recommended to operate between 3 - 4 psi, up to a maximum of 6psi. Expands To Fit Bag Neck Sizes (mm): (measured from the bottom of the cuff Encased stainless steel ring to support lower end COMPLIANCE: The Seeflex material complies with the following Pneumatic air inlet fitting connects to an air-line to inflate outer layer of Seeflex. Built-in pressure-relief valve (set at 6psi) to avoid over-inflation NOTE: If using in Atex Dust Zones, the up-line pipework and pneumatic air-line inlet fitting should be earthed. BFM® GLOBAL LTD. | E: [email protected] | WEB: BFMfitting.com V8 AUG 2023 regulations: FDA CFR 177.1680 and 177.2600, USDA & 3A (20-), (EC) 1935/2004, 2023–2006 & 10/2011. Manufactured from 3A 20-27 certified Seeflex Material and the BFM® cuff and spigot system is 3A certified 63-04 sanitary fitting.