Industrial Direct Drive 20
4Pages

INDUSTRIAL DIRECT DRIVE 20 Ambient (Unheated) Air Curtain Data SheetFor Mounting Heights To 20’(environmental separation) and 18’(insect control) STANDARD CONSTRUCTION • Single speed T.E.A.O. motor(s) - direct drive • Gray powder coated exterior (Optional: Custom Color or Stainless) • Split cabinet construction for fan assembly removal • Top Mounting only • Front air intake (Optional: top) • High efficiency Pro-V Nozzle Berner International certifies that the air curtains shown herein are licensed to bear the AMCA Seal. The ratings shown are based on tests and procedures performed in accordance with AMCA Publication 211 and comply with the requirements of the AMCA Certified Ratings Program. Rated data shown is for base (unheated) units. The AMCA Certified Ratings Seal applies to airflow rate, average outlet velocity, outlet velocity uniformity, velocity projection and power rating at free delivery only. Models IDC20-1084A, IDC20-1108A, IDC20-1132A, IDC20-1156A and IDC20-1180A are not licensed to bear the AMCA seal. NOTES: 1. Operation at 50 Hz will generate approximately a 17% reduction in air performance. 2. Consult factory for vertically mounted units. See sheet EP-440 for amp draws/total load requirements. Berner reserves the right to alter specifications without prior notice. VELOCITY PROFILE: Model IDC20-1060A MODEL NUMBER CONFIGURATION Sound level measured 10' (3m) from the unit in free field: 5, 7%, 10, 15 & (7% + 7%) hp motor(s): 73 dBA, 75 dBA, 76 dBA, 78 dBA & 78 dBA Sound data is not AMCA certified. www.berner.com Berner International 800.245.4455 111 Progress Ave. / New Castle / PA / 16101 / USA ©Copyright, 2017 Berner International

INTERNATIONAL CORP. Berner reserves the right to alter specifications without prior notice. www.berner.com Berner International Corporation 800.245-4455 111 Progress Ave. / New Castle / PA / 16101 / USA ©Copyright, 2015 Berner International Corporation

FRONT VIEW BOTTOM VIEW II ,_20 AMBIENT SYSTEM TOP INTAKE AIR CURTAIN MUST BE INSTALLED SO AIR STREAM IS NOT OBSTRUCTED WHEN DEFLECTED 20° TO EITHER SIDE OF (jT ELECTRICAL CONNECTIONS TO BE FLEXIBLE, FIELD VERIFY DIMENSIONS, ANCHORS TO SUPPORTING STRUCTURE BY OTHERS,

AMBIENT SYSTEM FRONT INTAKE END VIEW DAMPER CDNTRDL (TYP) BOTTOM VIEW NDZZLE ANGLE ADJUSTMENT (TYP)A NOTES: -NDZZLE WIDTH AIR CURTAIN MUST BE INSTALLED SE AIR STREAM IS NDT □ BSTRUCTED WHEN DERLECTED 20° TD EITHER SIDE DR (jT ELECTRICAL CONNECTIONS TD BE FLEXIBLE, FIELD VERIFY DIMENSIONS, ANCHORS TD SUPPORTING STRUCTURE BY OTHERS, ADEQUACY OP SUPPORTING STRUCTURE IS TD BE VERIFIED BY A PRDFESSIDNAL STRUCTURAL ENGINEER, LETTER "A" IN MODEL NUMBER DESIGNATES, AN AMBIENT UNIT, THE "F" DESIGNATES ERDNT INTAKE, DPTIDNAL CONTROL PANEL AVAILABLE: LEFT HAND MDUNT, RIGHT HAND MDUNT, OR REMOTE,...