Door Heaters

Door Heaters

Door Heaters

Product catalog summary

Technical Drawing Summary: Self-Formed Flange Specifications

This document provides detailed dimensional specifications and hole patterns for a self-formed flange, identified as Type 4PL.

Dimensions and Features

  • Overall Height (H): 1 5/8 inches
  • Outer Diameter (O.D.): 6 7/8 inches
  • Inner Diameter (I.D.): 3 3/4 inches (noted twice, possibly indicating two relevant inner diameters or a tolerance)
  • Airflow I.D. (BC): Not explicitly dimensioned but referenced, likely related to airflow passage within the flange

Hole Specifications

  • Type 4PL Holes: 9/16 inch diameter holes, equally spaced
  • Type 3PL Holes: 5/16 inch diameter holes

Additional Notes

  • The flange is self-formed, indicating it is shaped or formed during manufacturing rather than assembled from multiple parts.
  • Hole spacing is equal, which is critical for mounting or assembly alignment.

Summary: The document outlines a self-formed flange with specific outer and inner diameters, featuring two sets of holes with defined diameters and equal spacing. These details are essential for manufacturing, quality control, and assembly processes involving this flange type.

See more

Catalog excerpts

Door Heaters-1

"Ideal solution with negative Door Heater. . . problem of drafts or cold air from entering industrial buildings. INTERNATIONAL CORP.

 Open the catalog to page 1
Door Heaters-2

Door Heater problem when receiving doors air makes it difficult to maintain Berner Direct Gas Fired economical solution to this problem. A duct axial fan directs a high velocity stream of heated air towards the door opening. The hot air mixes with the incoming cold air providing a warm comfortable environment. The door heater is activated through a limit switch. When the door is opened there is a brief pre-purge and safety function check. The fan starts, directing a high velocity stream of hot air that heats the door heater can be mounted satisfy most applications. electric power and natural...

 Open the catalog to page 2
Door Heaters-3

STANDARD FEATURES • Electronic Flame Safeguard with LED Status Indicating Lights Magnetic Starter Control Transformer Ignition Transformer Interrupted Pilot Main Fuel Safety Valve High & Low Gas Pressure Switches* High Temperature Limit Switch Remote Station for Floor Mounting with Status Indicating Lights and Summer/Off/Winter Selector Switch Door Switch Rear Inlet Guard Block & Vent Valves** 12 Ga. Hot Rolled Steel Housing Finish is Air-Dry Alkyd Enamel Applied over Phosphatized Steel DOOR HEATER SELECTION For door sizes not covered, determine size and number of units on basis of appoximately...

 Open the catalog to page 3
Door Heaters-4

PRINCIPAL DIMENSIONS NOTE" Based on Natural Gas Specify Gravity 0.6,1000 BTU per cu. ft. CAUTION: The drive assembly or the periphery of the wheel of a fan less than seven (7) feet above the floor or working level must be guarded to be in accordance with OSHA regulations. SAFETY ACCESSORIES, APPLICATION AND USE WARNING The safe application and use of equipment supplied by Berner International, Inc. is the responsibility of the installer, the user, the owner, and the employer. Since the application and use of its equipment can vary greatly, Berner International, Inc. offers various product types,...

 Open the catalog to page 4
*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.