PL/1895 PLASTIC ADHESION PROMOTER
2Pages

TECHNICAL SHEET PLASTIC ADHESION PROMOTER DESCRIPTION PL/1895 is designed for a wide range of plastic parts in the automotive sector. Applicable on the following types: PP, PUR, PS, PA, PP-EPDM, ABS, PVC, GRP. Suitable for spot repairs and/ or small surfaces. Very easy appliaction and good adhesion on the above mentioned surfaces. SURFACE PREPARATION Clean the surface with water and soap. Once the surface is dry, degrease with thinner for plastics. If the plastic surface is not even, it is recommended to heat the piece to make any rests of the mould release agents reach the surface for an easier cleaning. If necessary finish sanding with P600 sanding paper and degreasing to eliminate the dust. APPLICATION Application viscosity Gravity spraygun Application pressure Evaporation time Drying time

TECHNICAL SHEET PLASTIC ADHESION PROMOTER SAFETY AND HYGIENE Recommendable to use the appropriate personal protective equipment during application to avoid irritation of breathing tract, skin and eye irritation. For professional use only. STORAGE Keep covered in a dry and ventilated place, avoiding direct exposure to sunlight. We advise Temperature above 5ºC, recommended between 15-30ºC. VOC PL/1895 has a lower organic solvent content than the traditional, compliant with the European Norm 2004/42/CE II(E) (840) <840 g/l The information contained in this Technical Data Sheet is based on our...