Bearing Condition Battery indicator Low/ 25%/ 50% / 75%/ full, graphical indicator Sensor bias indictor Normal/ open/ short, graphical indicator Back light LED back light, auto off Sensor's sensitivity Housing rating Power supply 9V alkaline battery x1(about 30 hours operation) 5 minutes after pressing any key About 300 gram (including battery) Hold function Freeze the display instantly Average function Display the averaged value of the latest 10 data Peak hold function Display the maximum value x10, and increase the reading precision(by 1 decimal place) Memory for 1000 measured data Review function Recall and display the saved data Download a pre-defined route from a PC, or upload archived data to a PC vPod and vPod II Smart Vibration Meters Each System comes equipped with: 1 each: Hard carrying case, Soft Carrying case, coiled cable for accelerometer, WR786A accelerometer, magnetic base, user manual, and 1 ea. RS-232C cable (vPodII only). Optional Software: Trendex Optional thermo meter and cable: Optex PT-3S Portable Non-Contact Thermometer, 0~200ºC 32905 Northland Court- St. Paul, MN 55045 Telephone: 651-257-6500 Fax: 651-357-4004 http://www.benstone.com

vPod and vPod II Smart Vibration Meters INTRODUCTION The vPod and vPod II are microprocessor-based vibration meters. Powered by the microprocessor, this family of meters can easily measure average, hold or peak hold vibration data, and display them with user selectable unit/detection. The battery charge indicator and sensor bias indicator is also a standard feature of vPod and vPod II. vPod II has built-in memory for storing up to 1000 archive data points. It can transfer data through the RS-232C port with a PC. GAIN AND PRECISION READING For those precision machines that have very low OPTIONAL...