Catalogs >
BENDER >
CC612 EV charge controller

CC612 EV charge controller
6Pages

Catalog excerpts

CC612 EV charge controller Charge controller for electric vehicle charging stations, wall boxes and street light charging points Preliminary datasheet

Open the catalog to page 1

Product description The charge controller monitors the internal hardware of charging systems such as the meter, the user interface module or the socket-outlet. It can be operated as an “always-on system” that is always connected to a mobile network. The master variant supports 4G mobile networks. Communication with a backend system is possible via the OCPP application protocol. All specified messages in OCPP are supported as well as some vendor-specific extensions based on the DataTransfer message. Integration tests with the backend implementations of providers (e.g. has-to-be, Virta and...

Open the catalog to page 2

• Data management and control functionality of the charge controller: – Termination of the charging process after tripping of the residual current device (RCD) due to a residual current. – Detection of critical fault currents by the RCM sensor. For the vehicle owner, this can be an earlywarning, provided that the charge controller is connected to an energy management system and that it supports this function. – Load current and cooling control (via a temperature sensor) The charge controller has internal temperature sensors (on the inside of the controller housing) that allow the...

Open the catalog to page 3

Charging system with a type 2 socket and an intermediate relay L1 A Connection locking engine B Connection socket User Interface D Connection Current Transformer (CT) V Bottom view Intermediate relay Optocoupler input 2 Relay 1: Control pin contactor Connection Control Pilot Connection Proximity Pilot Current Transformer (CT) with plug Terminal Modbus/eHZ meter (RJ10) Terminal User Interface (RJ45) Frontal view Dimension diagram Dimensions in mm 22,6

Open the catalog to page 4

Technical data Insulation coordination acc. to IEC 60664-1/IEC 60664-3 Rated voltage Overvoltage category/Pollution degree Rated impulse withstand voltage Altitude Supply voltage Nominal voltage Operating range of the supply voltage Nominal current Residual direct current monitoring module* Measuring range 100 mA Response values: DC 6 mA Residual current IΔn -50…0 % Response tolerance IΔn Restart sequence value: DC 6 mA < 3 mA * patented 6 mA DC residual current tripping (Patents: EP 2 571 128 / US 9,397,494 / ZL 201210157968.6 / CN 103001175, EP 2 813 856) Wireless parameters (Optional for...

Open the catalog to page 5

Ordering information RDC-MD 2) Ready, Alarm Ready, Alarm Powerline Communication acc. to ISO/IEC 15118 The charge controller with residual direct current monitoring module (RDC-M) only works in combination with the measuring current transformer (to be ordered separately). Different cable lengths are available. Accessories Designation RFID114 with RJ45 cable (length 500 mm) RFID117-L1 with RJ45 cable (length 500 mm) Measuring current transformer CTBC17 (PCB variant)1) Measuring current transformer CTBC17 (cable variant, cable length 325 mm)1) Connection cable CTBC17-Cable1470 incl. clip...

Open the catalog to page 6

CC612 EV charge controller 6Pages

Catalog excerpts

All BENDER catalogs and technical brochures

CC612 EV charge controller
6Pages