Copying of this document, disclosing it to third parties or using the contents there for any purposes without express written authorization by use illegally forbidden. Any offenders are liable to pay all relevant damages

Customer: Standard type Page 2 of 7 PIN description: Editor.: R&D-PD-NPI D Copying of this document, disclosing it to third parties or using the contents there for any purposes without express written authorization by use illegally forbidden. Any offenders are liable to pay all relevant damages

Differential Current Sensor acc. to the standard IEC62752-1:2016 K-No.: 26893 Customer: Standard type Typical application diagram: power contactor driver circuit working voltage to driver control electronics control electronics e.g. charge Absolute maximum ratings(8): Min VCE IC VCC UMAX VTEST-IN, low VTEST-IN, high Collector-Emitter voltage (PINs 1, 3 and 4) Collector current (PINs 1, 3 and 4) Maximum supply voltage (without function) Maximum rated voltage of primary conductors TEST-IN Input Voltage, low level TEST-IN Input Voltage, high level Stresses above these ratings may cause permanent...

Differential Current Sensor acc. to the standard IEC62752-1:2016 K-No.: 26893 Customer: Standard type Page 4 of 7 Final Tests: (Measurements after temperature balance of the samples at room temperature, SC=significant characteristic) Vcc Icc TEST-IN (SC) X6-OUT (normal) X30-OUT (normal) ERROR-OUT (normal) X6-OUT (activated) X30-OUT (activated) ERROR-OUT (activated) TC1 TC2 TC3 PWM-OUT (frequency) PWM-OUT (duty-cycle) LV1 LV2 LV3 LV4 ERROR-OUT voltage activated @5V, 1kΩ (pull-up)* Trip current 1 – X6 Trip current 2 – X6 Trip current 3 – X30@50Hz PWM-OUT frequency PWM-OUT duty-cycle @6mA DC Limit...

Customer: Standard type Requalification Tests: (replicated every year, Precondition acc. to M3238) Temperature of the primary conductor should not exceed 105°C. Vcc during Test-IN function test must be in rated range. If the trip-level Ian1/Ian2 is accomplished the corresponding output X6-OUT/X30-OUT will change its state from low-level (GND) to high impedance. Depending on the existence of the differential current Ia, the outputs X6-OUT/X30-OUT will remain in their states until Ia is below the recovery threshold Iarm/Iari2. Copying of this document, disclosing it to third parties or using the...

Copying of this document, disclosing it to third parties or using the contents there for any purposes without express written authorization by use illegally forbidden. Any offenders are liable to pay all relevant damages

Customer: Standard type Differential Current Sensor acc. to the standard IEC62752-1:2016 Item no.: T60404-N4641-X920 Date: 11.10.2021 Specification X6-OUT Normal condition High impedance High impedance High impedance High impedance High impedance High impedance Error, system fault All other conditions not mentioned in the table are not possible. If these conditions occur, the sensor is in unknown state and describes an Error. Table 1: Possible output states Bender GmbH & Co. KG • Londorfer StraBe 65 • 35305 Grunberg • Germany eMobility • [email protected] • www.bender.de/loesungen/emobility...