Integrated power module for charge controllers

Device features • Surge Protection Device (SPD) • integrated DC power supply, including a ICC1314 charge controller • integrated residual current transformer for DC fault current monitoring • integrated temperature sensors • 20-pole connector for connection to the charge controller by using a connection cable Integrated power module for charge controllersIntended use The IPM1300 integrated power module, referred to as power module in the following, is a component for the set-up of Mode 3 charging stations for electric vehicles (EV). It is intended exclusively for use with Bender charge controllers...

a Charge controller connection, 20 pole b 12 V power supply unit d Connection, type 2 connector f Measuring current transformer

The following wiring diagrams illustrate the wiring options of the power module to the ICC1314 charge controller.

Three phase connection Legend for both connection options

£ 2000 m above mean sea level Technical Data Rated voltage Overvoltage category (terminal e) Pollution degree Rated impulse voltage Operating altitude AC network connection, single-phase / three-phase (terminal block e (L1, L2, L3, N, PE)) Nominal voltage tolerance Nominal voltage tolerance1 max. Charging current Classification of climatic conditions acc. to IEC 60721 Classification of mechanical conditions acc. to IEC 60721 Short-circuit current carrying capacity when using PE monitoring Connection, type 2-socket AC single-phase / three-phase (terminal block d (L1, L2, L3, N, PE)) The IPM1300...

2 ± 0.2 mm - or all other dimensions according to DIN ISO 2768-f x not recommended, only insulated J Red markings:possible fixing points

Bender GmbH & Co. KG Londorfer Straße 65 35305 Grünberg Germany Tel.: +49 6401 807-707 [email protected] www.bender.de © Bender GmbH & Co. KG, Germany Subject to change! The specified standards take into account the edition valid until 10.2025 unless otherwise indicated.