ICC1314 Charge controller for charging systems for electric vehicle charging

Charge controller for charging systems for electric vehicle Device features • Charge controller in accordance with IEC 61851-1 (charging mode 3) • integrated WiFi module for configuration and connection with other charging systems • Suitable for single-phase or three-phase charging of electric vehicles up to 80 A, depending on the current carrying capacity of the integrated power module which is used • integrated residual direct current monitoring module with residual current transformer for DC residual current monitoring (external RCD type A required) - 1 CONFIG interface (type B) for configuration...

Functional description The charging system consists of a charge controller in combination with an integrated power module (IPM). The IPM is connected to a charging socket or to a permanently mounted cable with a type 1 or type 2 plug. • The charging system can be equipped with an electricity meter. Modbus RTU meters can be connected directly to the device. In addition, a second meter can be connected for energy management via Modbus TCP using an Ethernet or WiFi interface. • A DC 12 V power supply via integrated power module is needed for operation. • Option to use an HMI module with RFID reader...

RBENDER Legend

Technical data Overvoltage category (terminal e) III Rated impulse voltage 800 V Operating altitude AMSL < 2000 m Supply voltage DC 12 V (Terminal P) Input voltage (HIGH) DC 11.4 V...25.2 V max. potential difference to PE/GND 50 V* * The potential difference between the optocoupler inputs and other inputs/ outputs must be less than 50 V. Supply voltage range Us max. power consumption Average power consumption SMA plug connector(terminal G) or U.FL plug connector for 4G antenna DC 12 V voltage source (Terminal A (12 V, 0 V)) Relay 1 and 2 (12 V) (Terminal K: Relay 13/14 and Relay 23/24) rated...

RBENDER Declaration of conformity Standards and approvals Hereby, Bender GmbH & Co. KG declares that the device covered by the Radio Directive complies with Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following Internet address: Ordering information

Bender GmbH & Co. KG Londorfer Straße 65 35305 Grünberg Germany Tel.: +49 6401 807-0 [email protected] www.bender.de © Bender GmbH & Co. KG, Germany Subject to change! The specified standards take into account the edition valid until 02.2025 unless otherwise indicated.