COMTRAXX® COM465IP/COM465DP Condition Monitor with integrated Gateway for the connection of Bender devices to PROFIBUS DP and Ethernet-TCP/IP networks

COMTRAXX® COM465IP/COM465DP Condition Momtor wM tategrated Gateway for the connection of Bender devices to PROFIBUS DP and Ethernet-TCP/IP networks Data transfer interfaces SNMP 28MQTT Device features • Condition monitor for Bender systems • Integrated modular gateway between Bender systems and TCP/IP enables remote access via LAN, WAN or Internet • Range of functions adjustable through function modules • Support of devices that are connected to the internal or external BMS bus, via BCOM, via Modbus RTU or Modbus TCP • Individual visualisation can be generated, which is displayed via the web...

Basic device (without function modules) • Condition monitor with web interface • Interfaces for the integration of devices - Internal BMS bus (max. 150 devices) and external11 BMS bus (max. 99 x 150 devices) - Modbus RTU and Modbus TCP (max. 247 devices each) • Remote display of the latest measured values, status/alarm messages and parameters11 • Gateway to Modbus TCP: Reading the latest measured values, status/alarm messages from addresses 1...10 of the respective interface via Modbus TCP • Gateway to Modbus RTU: Reading the latest measured values, status/alarm messages from addresses 1.10 of...

100 virtual devices with 16 channels each can be created. 1600 data points from third-party devices (via Modbus RTU or Modbus TCP) can be integrated into the system. For UL applications, the following must be observed: • Maximum ambient temperature: 55 °C • Use 60/70°C copper lines only

Wiring diagram Wiring diagram COM465…P (example) PROFIBUS DP for COM465DP only

Technical data ( )* = Factory setting Insulation coordination in acc. with IEC 60664-1/IEC 60664-3 Rated impulse withstand voltage/overvoltage category 4 kV / III Protective separation (reinforced (A1/+, A2/-) - [(AMB, BMB), (ABMS, insulation) between BBMS), (X2), (X3, X4), (PROFIBUS DP)] Supply voltage Supply voltage Us Frequency range Us Power consumption Connection Cable length Data rate HTTP mode DHCP nnn.nnn.nnn.nnn can always be reached via Netmask Protocols (depending on function module selected) 10/100 MBit/s, autodetect HTTP/HTTPS (HTTP)* on/off (on)* 5.60 s (30 s)* (192.168.0.254)*...

Classification of climatic conditions acc. to IEC 60721 Operating mode master/slave (master)* Baud rate Cable length shielded, one end of shield connected to PE Connection type see connection "Push-wire terminal X1" Terminating resistor Supported Modbus RTU slave addresses Connection type pluggable push-wire terminals Supported devices Trap support Interface/protocol Ethernet/PROFINET Operating mode slave (IO device) queries to all devices (channels) possible Push-wire terminals flexible with ferrule with/without plastic sleeve 0.25.2.5 mm2 Multiple conductor, flexible with TWIN 0.5.1.5 mm2 ferrule...

Certification by the PROFIBUS Nutzerorganisation e.V. (PNO) is available. PROFIBUS conformity: Z02007 Dimensions Dimension diagram (in mm) Ordering information Device

Application example

Bender GmbH & Co. KG Londorfer Straße 65 35305 Grünberg Germany Tel.: +49 6401 807-0 [email protected] www.bender.de © Bender GmbH & Co. KG, Germany Subject to change! The specified standards take into account the edition valid until 09.2025 unless otherwise indicated.