LED-UV Integrator Application: Due to its compact and flat design, the Beltron LED UV Integrator is particularly well suited for continuous flow dryers with a low throughput height. Areas of application include, for example: - LED / UV dryer - PCB exposures - Copying equipment General: The Beltron LED UV Integrator is a high-quality measuring device for determining the UV dose. On the back of the device a UV sensor is located, which detects the LED / UV radiation. The LCD display directly reflects the measured value in millijoules per square centimeter (mJ / cm²). The LED UV integrator is powered by a 3.6 volt lithium battery, which is located inside the device. By using particularly energy-saving circuits, the battery lasts for about 10,000 operating hours. A special filter blocks the visible as well as the IR range of the radiation so that only the desired spectral range will be measured. Handling: To take a measurement, proceed as follows: 1.) Activate the LED UV integrator by pressing the toggle switch. An irradiation value (dose) of 0 mJ / cm² is displayed on the LCD-Display. 2.) Turn the LED UV integrator in a position that the sensor faces to the radiation source. Then let the integrator run under the UV source respectively allow it to illuminate for the desired time 3.) After completion of the exposure, the measuring value is shown on the display e.g. 550 mJ/cm². 4.) After completing the measurement, switch off the device via the toggle switch. When switching on again, the LED UV integrator is reset to „zero“ for the next measurement Please note that the housing temperature must not exceed 110 ° for 10 seconds! The LED-UV Integrator is used successfully in: printing industry, electronic industry, plastic industry, building materials industry, textile industry, packaging industry, pharmaceutical industry, automotive industry, glass industry and engineering. These are just a few examples from the various partner portfolio of Beltron. Beltron GmbH Siemensstraße 6 | D-63322 Rödermark | Phone: +49 6074 89199-0 | [email protected] | www.bel

LED-UV Integrator Application: Due to its compact and flat design, the Beltron LED UV Integrator is particularly well suited for continuous flow dryers with a low throughput height. Areas of application include, for example: - LED / UV dryer - PCB exposures - Copying equipment Technical Information LED-UV Integrator Display: 6-digit LCD-display 0 - 999999 mJ/cm² Dimensions: 80 x 145 x 12 mm Weight: approx 500 gr. Switch: On / Off / automatic Off Power supply: 3,6 V Lithium-Battery Power consumption: 100μA (10.000 operating hours) Casing: Aluminium casing chromium plated Spectral measuring range:...