S130
4Pages

Catalog excerpts

EQUIPMENT Voltage adjustment trimmer; Stability control trimmer; V/Hz threshold setting trimmer; Max excitation current setting trimmer; Protection against over voltage (factory pre-set at +25% before resin potting, the valve can be customized according to customers' needs); Minimum self-excitation voltage: 3,5 Volt; Wire jumper (1) for the possible connection to a potentiometer of 1000Q - 1/4 Watt for remote voltage setting (variation range 10%); Wire jumper (2) for freq. selection 50 or 60Hz; Wire jumper (3) (red) for operation at 115 V. Parallel input (to match with SI 55) and...

Open the catalog to page 3

INSTALLATION AND ASSEMBLY The regulator must be installed inside the machine or inside the control and command panel, in order to be protected against accidental contacts. Its installation should be done in an easily and accessible place with a clean and dry air exchange in recommended. Use the two holes on the corners and 4MA screws to secure the machine. ACCEPTANCE Regulators are normally supplied with standard packaging. With a small extra charge and upon customer request, a special packaging can be provided (for sea shipping, airfreight, etc). At the receipt of the package, check the...

Open the catalog to page 4