Catalogs >
Bell & Gossett Domestic Pump >
Series CU and UH Underground Condensate Units

Series CU and UH Underground Condensate Units
10Pages

Catalog excerpts

Series CU and UH Underground Condensate Units - 1

Domestic® Pump Series CU & UH TM UNDERGROUND CONDENSATE UNITS

Series CU and UH Underground Condensate Units - 3

Parts List The nameplate identifies the unit by its model number and capacities are noted. Specific pump information is determined by identifying the model number, sump depth and the motor horsepower (which is noted on the motor nameplate). LARGEST MOTOR The following procedure will result in proper parts selection: 1. Determine from the nameplate the unit model number and its pumping capacity. 2. Refer to the motor nameplate to determine the correct motor horsepower. 3. Refer to installation records or plans to determine sump depth. In the event that the depth is not specified, physical...

Open the catalog to page 3

Series CU and UH Underground Condensate Units - 4

PUMP SELECTION TABLES FOR CU SERIES UNDERGROUND UNITS Square Foot EDR Discharge Size Model Number Pump Model Impeller Diameter

Open the catalog to page 4

Series CU and UH Underground Condensate Units - 5

HOAT SWITCH SWITCH BRACKE PIPE NIPPLE - RETAINING RING. SHAFT BEARING HOUSING-- CONTROL BASE --CUSHION SPH}bR FLFXIBLF COUPLING IHRUST BALL OCAHING WITH — MECHANICAL SEAL — — MOI'OR SUPPOH j-^Ch-'iRGF FLANGE - EXPANSION JOINT DISCHARGE PIPE CASE HiNG BRASS --CUSHION SfiOEA FLEUBU COUPLING THRUST CALL BEARING WITH SINGLE SEAL AMO PHOVISIOM DISCHARGE FLANGE EXPANSION JOINT DISCHARGE: PIPE — - CASE HING BFtASS - DRAIN PLUG FIG. 6 FOR CLARITY OF ILLUSTRATION, SOME PARTS ARE SHOWN DISPLACED

Open the catalog to page 5

Series CU and UH Underground Condensate Units - 6

SERIES CU/SERIES UH PARTS LIST (1) For units manufactured before 1992, a Pump Head with Bearing should be furnished instead of lower bearing only due to design changes.

Open the catalog to page 6

Series CU and UH Underground Condensate Units - 7

(1) For units manufactured before 1992, a Pump Head with Bearing should be furnished instead of lower bearing only due to design changes.

Open the catalog to page 7

Series CU and UH Underground Condensate Units - 8

UNDERGROUND 626 (UG626) PART NAME Rubber Insert for Flexible Coupling Coupling Key Coupling Guard Motor Support Upper Ball Bearing Lower Bearing 1 Shaft Retaining Ring Upper Bearing Housing Upper Bearing Housing Cover Mechanical Seal Seal Collar Collar Set Screws (2 req.) Pump Shaft Support Column Support Column Extension Intermediate Bearing Housing Intermediate Bearing Discharge Elbow Pump Head w/Bearing Pump Case w/Wearing Ring Wearing Ring Impeller Impeller Locknut or Screw Impeller Washer Discharge Pipe Discharge Flange O Ring for Discharge Flange Motor Support Gasket Discharge Flange...

Open the catalog to page 8

Series CU and UH Underground Condensate Units - 9

MECHANICAL ALTERNATOR ASSEMBLY DESCRIPTION Complete Assembly Float Ball Collar (Float Stop) (2 req) Support Base Mechanical Alternator FLOAT SWITCH ASSEMBLIES DESCRIPTION Complete Assembly Float Ball Collar (Float Stop) (2 req) Support Base Float Switch

Open the catalog to page 9

Series CU and UH Underground Condensate Units - 10

MOTOR & RELATED COMPONENTS * Notes that Standard Motors are modified by removal of threaded tip at the factory * Motor side coupling halves are pinned in position Morton Grove, Illinois 60053 Bell & Gossett is a trademark of Xylem Inc. or one of its subsidiaries. Let's Solve Water

Open the catalog to page 10