DS 214 Electronic Pressure Switch for Very High Pressure Thinfilm Sensor accuracy according to IEC 60770: standard: 0.35 % FSO The electronic pressure switch DS 214 for very high pressure up to 2 200 bar has been designed especially for use in plant and machine engineering as well as in mobile hydraulics. Nominal pressure from 0 ... 600 bar up to 0 ... 2 200 bar The DS 214 has one 1 contact with standard version, this can optionally be upgraded up to four independent contacts. Contacts 1, 2 or 4 independent PNP contacts, freely configurable Via the rotatable module with an integrated 4-digit display the DS 214 can be programmed easily and comfortably. Analogue output 2-wire: 4 ... 20 mA 3-wire: 4 … 20 mA / 0 … 10 V others on request Special characteristics indication of measured values on a 4-digit LED display pressure sensor welded extremely robust and excellent longterm stability Plant and machine engineering Commercial vehicles and mobile hydraulics adjustability of span and offset (4 ... 20 mA / 3-wire) customer specific versions BD SENSORS GmbH BD-Sensors-Straße 1 D - 95199 Thierstein www.bdsensors.de info@

DS 214 Electronic Pressure Switch Input pressure range Nominal pressure gauge Overpressure Contact 1 Standard Options Max. switching current Accuracy of contacts 2 Repeatability Switching frequency Switching cycles Delay time 1 Technical Data 1 PNP contact 2 independent PNP contacts 4 independent PNP contacts 4 ... 20 mA / 2- and 3-wire: 0 ... 10 V / 3-wire: ≤ ± 0.35 % FSO ≤ ± 0.1 % FSO max. 10 Hz > 100 x 106 0 ... 100 sec (possible with M12x1, 8-pin for 4 ... 20 mA/3-wire) contact rating 125 mA, short-circuit resistant; Vswitch = VS − 2 V contact rating 125 mA, short-circuit resistant max. 1...

DS 214 Electronic Pressure Switch Technical Data Wiring diagrams 2-wire-system (current) p Pin configuration Electrical connection Supply + Supply – Signal + (only 3-wire) Contact 1 Contact 2 Contact 3 Contact 4 Shield Electrical connections (dimensions mm / in)

DS 214 Electronic Pressure Switch Technical Data © 2024 BD|SENSORS GmbH – The specifications given in this document represent the state of engineering at the time of publishing. We reserve the right to make modifications to the specifications and materials. According to EN 837, the pressure port and the complement, at pressure over 1000 bar must be preferably made of stainless steel with a tensile strength of RP > 260 N/mm² in accordance with DIN 17440. The maximum allowed pressure is 1600 bar! Rotatability of display module www.bdsensors.de [email protected]

Analogue output Contact 1 contact 2 contacts 4 contacts 0.35 % FSO customer Electrical connection male plug M12x1 (5-pin) / plastic version male plug M12x1 (8-pin) / plastic version male plug M12x1 (5-pin) / metal version male and female plug ISO 4400 male plug Binder series 723 (5-pin) customer Mechanical connection G1/2" EN 837 M20x1.5 internal thread customer Seal without (welded version) customer Special version standard customer with connector ISO 4400 and output 2-wire version only max. 1 contact possible; with 3-wire version no contact possible 4 contacts and M12x1, 8-pin only possible...