Model UG Force Transducers with Overload Protection Description Made from 2024 aluminum alloy, the UG force transducer is developed as an overload-protected device to measure the forces where the extremeoverload happens frequently in applications. Based on the BCM precision strain gauge technology, the UG force transducer works on bending beam principle with measuring capacity from 3N to maximum 300N. Its measuring accuracy is standardized to 0.2%fs, while its output sensitivity is designed to reach 2.0 mV/V corresponding to the full scale load of its required capacity. The UG force transducer is developed as a counterpart of the BCM UF force transducer which has no overload-protection. The two models, UF and UG, can be installed either vertically or horizontally. When the transducer is installed in its vertically position the bending beam can be either pulled down or pulled up, depending on the direction of force to measure. Therefore both the UF and UG are designed to symmetrical force transducers and are able to measure, after installation, the two directional forces in application. Features double bending beam hanging scales overload protected force teasters customized mechanical interface capacity: 3N, ..., 300N protection rating: IP65 BCM SENSOR TECHNOLOGIES BVBA Industriepark Zone 4, Brechtsebaan 2 website: www.bcmsensor.com B-2900 Schoten - Antwerpen, BELGIUM email: [email protected]

Force Transducers with Overload Protection Electrical Connection BCM SENSOR TECHNOLOGIES BVBA Industriepark Zone 4, Brechtsebaan 2 Tel.: +32-3-238 6469 website: www.bcmsensor.com B-2900 Schoten - Antwerpen, BELGIUM Fax: +32-3-238 4171 email: [email protected]

Model UG Force Transducers with Overload Protection Technical Data Parameter overload output sensitivity output signal Units overload protected amplified-signal output zero unbalance bridge resistance insulation resistance compensated temperature range operating temperature range storage temperature range temperature coefficient of zero temperature coefficient of span load cell body material aluminum alloy environment protection Notes: 1. For customized capacity, consult BCM.. 2. “fs” refers to full scale pressure or rated pressure. 3. Including non-linearity, hysteresis and repeatability. The...

Model UG Force Transducers with Overload Protection Ordering Information position (pos.) 1: model UG pos. 2: capacity 100N 3N 250N 5N 300N 10N 25N 50N pos. 3: output signal 1.5mV/V (standard) pos. 5: customized specifications “(*)” is necessary only if any customized parameter is required, otherwise it is neglectable. pos.1 Examples of Ordering Code standard load pin: UG-50N-1.5mV/V-1%fs customized load pin: UG-80N-4/20mA-0.2%fs-(*) BCM SENSOR TECHNOLOGIES BVBA Industriepark Zone 4, Brechtsebaan 2 website: www.bcmsensor.com B-2900 Schoten - Antwerpen, BELGIUM email: [email protected]