Catalogs >
BCM SENSOR TECHNOLOGIES bv >
Model A1 Sensor Signal Conditioner

Model A1 Sensor Signal Conditioner
1 / 2Pages

Catalog excerpts

Model A1 Sensor Signal Conditioner Model A1 Sensor Signal Conditioner (SSC) is designed as a low profile SSC to be used with any sensors which are built with Wheatstone bridge circuit. It amplifies an input (i/p) millivolt signal of sensors to a standard analog signal which can be directly input to a PLC (programmable logic controller) or any computer based data acquisition systems. A1 SSC can process the i/p sensitivity from 1mV/V to 12mV/V and the sensor is powered by an excitation voltage in a range of 5, ..., 10 Vdc. A1 SSC provides a factory pre-set regulated excitation voltage (5, ..., 10 Vdc) to the sensor. The o/p signal of A1 SSC can be either the current loop (4~20 mA), or the voltage signal (0~5 Vdc or 0~10 Vdc). The “offset” and “span” of the o/p signal of A1 are adjustable via two potentiometers located at the o/p end of A1 (refer to the diagram below). The circuits of A1 SSC are protected by an anodized aluminum housing. The A1 SSC is produced to have environment protection level IP66. Features: ● work with any sensors based on strain gauge technology ● input (i/p) sensitivity: 1mV/V, ..., 12mV/V ● output (o/p): 4~20 mA, 0~5 Vdc or 0~10 Vdc ● factory pre-set bridge excitation voltage: 5, ..., 10 Vdc ● “offset” and “span” adjustment via potentiometers ● polarity protection circuit ● environment protection to IP66 Z: offset adjustment G: span adjustment BCM SENSOR TECHNOLOGIES BVBA Industriepark Zone 4, Brechtsebaan 2 website: www.bcmsensor.com B-2900 Schoten - Antwerpen, BELGIUM

Open the catalog to page 1

Model A1 Sensor Signal Conditioner Technical data: Parameters number of working channels input sensitivity output signal accuracy load resistance supply voltage bridge excitation voltage* operating temperature range electrical interface electronics housing material environment protection net weight Specifications 1 1, ..., 12 4~20 (standard), 0~10 0~5, 0~10 ≤ ±0.1 ≤ 1000 for 4~20 mA current loop > 1000 for voltage output 12, ..., 30 5, ..., 10 -30 ~ +85 4-hole female connector with mating detachable connector 4-pin male connector with mating detachable connector** anodized aluminum IP66...

Open the catalog to page 2

Model A1 Sensor Signal Conditioner 1 / 2Pages

Catalog excerpts

All BCM SENSOR TECHNOLOGIES bv catalogs and technical brochures

Model A1 Sensor Signal Conditioner
1 / 2Pages