Model 301B
1 / 4Pages

Catalog excerpts

Mono-Block Ceramic Pressure Sensors The 301B is piesoresistive pressure sensor based on ceramics. By means of thick film technology, the bridge circuit is directly printed at the back of a ceramic pressure diaphragm. Thanks to excellent corrosion resistance, the other side of the diaphragm can be exposed to measured media without any additional protection. And this sensor is widely used in HVAC As the 301B is made from one piece of AI203 ceramics (mono-block structure), it possesses a rigid structure and can be mounted directly in a case by using an O- ring or to a metal fitting. The sensor has the standard diameter of 18mm and are temperature compensated. There are also various options of output signal available on request. • excellent corrosion resistance • various output options: 2.5mV/V, impact and vibration resistance • easy mounting • automotive industry • HAVC systems • liquid level control • process control systems • pneumatic and hydraulic controls • biomedical instrumentation BCM SENSOR TECHNOLOGIES BVBA Industriepark Zone 4, Brechtsebaan 2 Tel.: +32-3-238 6469 website: www.bcmsensor.com B-2900 Schoten - Antwerpen, BELGIUM Fax: +32-3-238 4171 email: sales@bc

Open the catalog to page 1

Mono-Block Ceramic Pressure Sensors Technical Data General conditions for measurements: media temp. = 25°C ±1°C, ambient temp. = 25°C ±1°C. Notes: 1. For customized pressure ranges, consult BCM. 2. "fs" means full scale and refers the maximum working pressure or rated pressure. 3. Measured at full scale pressure. 4. Combined non-linearity, hysteresis, and repeatability. 5. Calculated as a rate of output change between 0°C and 70°C, and normalized by the output at 25°C. 6. Response time for a 0 bar to fs step change, 10% to 90% rise time of leading edge. 7. 4 contacts for millivolt output...

Open the catalog to page 2

Model 301B Mono-Block Ceramic Pressure Sensors Electrical Interface solder pads flying wires wire length = 100mm flat cable cable length = 16mm, for conditioned-signal output (10%~90%Vc ratiometric) BCM SENSOR TECHNOLOGIES BVBA Industriepark Zone 4, Brechtsebaan 2 website: www.bcmsensor.com B-2900 Schoten - Antwerpen, BELGIUM email: sales@bcmsensor.com

Open the catalog to page 3

Model 301B Mono-Block Ceramic Pressure Sensors Ordering Information position (pos.) 1: model 301B pos. 2: pressure ranges and references G: gauge pressure 2bar G 40bar G 5bar G 60bar G 10bar G 100bar G 20bar G 250bar G 25bar G 400bar G pos. 3: output signal 2.5mV/V (standard) 10%/90%Vc = 10%~90%Vc ratiometric pos. 4: temperature compensation T1 = 0~70 °C pos. 5: electrical interface SP: solder pads (standard and only for mV output) PH: pin header (standard for conditioned-signal output) FW: flying wires, PVC, 100mm FC: flat cable, 16mm (only for 0.5/4.5 V output) pos. 6: customized...

Open the catalog to page 4

Model 301B 1 / 4Pages

Catalog excerpts

All BCM SENSOR TECHNOLOGIES bv catalogs and technical brochures

Model 301B
1 / 4Pages