Instructions Tie-Lok II Tool Always wear safety glasses when operating hand tool. 1. Turn tension adjustment knob until desired tension setting is displayed in tension indicator window. Space between numbers counts as one-half 2. Extend handle open to release gripping mechanism and insert clamp tail into tool through front load entry. 3. Squeeze handle repeatedly to tighten band around object. Be sure to release handle completely to use full pull-up stroke of tool. Buckle must be secure against the tool head and nestled between the two retention clips. Once the preset tension has been reached, the handle will no longer release completely. 4. To cut-off excess clamp tail, squeeze handle one last time. 5. The tool must be reset by, extending the handle out until it snaps into place, the tool will be ready to apply the next 6. Tension Setting Range: 4799 Dahlia Street BAND-IT-IDEX, Inc. 2006 Denver, CO 80216-3070 USA AM RINHT<, RP(,PRVPFI P: 1 -800-525-0758 Page 1 Of 4 rightS reserved

18, 32 See list of tool head parts on next page 14, 32 cut-off link and pin shown as a reference from next page BAND-IT-IDEX, Inc. A Unit of IDEX Corporation 4799 Dahlia Street Denver, CO 80216-3070 USA P: 1-800-525-0758 F: 1-800-624-3925 Document # A92051 rev. H © Copyright BAND-IT-IDEX, Inc. 2006 All rights reserved

ReDair Parts jr - BAND-IT A92079 Refer to website for warranty information: http://www.band-it-idex.com/warrantv.html Covered under US Patent #5743310 4799 Dahlia Street BAND-IT-IDEX, Inc. 2006 Denver, CO 80216-3070 USA AM RINHT<, RP(,PRVPFI

Repair Harts =tr-*: ™*<"«™«MMM* Tie-Lok II Tool 1 Bearing, thrust (3 pieces) 1 Decal, tension indicator 1 Body, left, black 1 Lever, pull-up, front load 1 Grip, textured, blue 1 Body, right, black Adhesive, cyanoacrylate Grease, extreme pressure Red Loctite (high strength) Blue Loctite (med. strength) Link, cut-off Lever, cut-off Dimple punch Clip, left Tool head Clip, right Gripper, hold 4799 Dahlia Street BAND-IT-IDEX, Inc. 2006 Denver, CO 80216-3070 USA AM RINHT<, RP(,PRVPFI