MODEL BL508 DIFFERENTIAL PRESSURE DEADWEIGHT TESTSER
1Pages

MODEL BL508 DIFFERENTIAL PRESSURE DEADWEIGHT TESTSER PRESSURE RANGE SELECTABLE SHEET Part Number GCY7 GCY20 GCY60 The main challenge of defining ΔP at high line pressures comes from the very high ratio of the line pressure to the differential pressure, and the fact that relative small instabilities in the magnitude of line pressure are very large in comparison to the small magnitude of the differential pressure. The BL508 differential pressure deadweight tester uses the principle of high line differential measurement with two oil lubricated / gas operated pistons allows setting and maintaining the line pressure with an uncertainty much lower than the overall measurement uncertainty on either piston. The master and slave pistons are cross-floated at the line pressure prior to making differential measurement to minimize the contribution of line pressure errors to differential pressure. High line differential mode relies upon the very high sensitivity of piston cylinder unit to set and stabilize low differential pressure relative to high line pressures. (The 60MPa use oil lubricated / oil operated piston) Measure the differential pressure under the high static pressure 60MPa Each piston and cylinder unit can be used separately to measure gauge pressure Two oil lubricated / gas operated pistons Over-pressure protection is integrated Built-in oil/gas separator Primary pressure standards in laboratories Precision pressure measurement Balun Technology Co., Ltd Add: 1322, F/3, Bldg 1, 33 Zique Rd, Haidian, Beijing100095, China Accuracy: 0.01%rd for gauge pressure by using single piston, or it is (2Pa + 5x10-7P + 1x10-4 △ P) for differential pressure buy using dual pistons together Piston material: Tungsten carbide Cylinder material: Tungsten carbide Mass material: 304 stainless steel Hydraulic base material: Aluminum alloy Seal material: Buna-N, FTM, PTFE, Copper Alloy Medium: Pure Nitrogen ( ≤ 20MPa), Sebacate (60MPa) Gravity: Standard 9.80665 m/s², or customize local gravity. Pressure units available: MPa, bar, psi (optional) Pressure connector: Metric (NPT and BSP is optional) Base dimension: 540 mm (H) x 625 mm (L) x 480 mm (D) Base weight: Appro.35kg BL508 Static pressure deadweight tester base Master piston cylinder unit Master 304 stainless steel mass set Master mass carrier Slave piston cylinder unit Slave 304 stainless steel mass set Slave mass carrier Adapter kits (1/4� NPT, ½� NPT, G¼, G½) Connection hoses Transit case OPTIONAL ACCESSORIES AND SERVICES ■ ■ ■ ISO17025 accredited calibration certificate (P/N:9000-508) Oil-Water Separator 70 MPa (P/N:1558-70) Forged 316 stainless steel mass set (P/N: MS-316) Model BL508 / pressure part number / accuracy / gra