- Catalogs
- BALLOFFET S.A.S.
- Typical profi le Single Crystal Diamond dies up to 50 μ
Typical profi le Single Crystal Diamond dies up to 50 μ
1 / 1 PageView full catalog
Typical profi le Single Crystal Diamond dies up to 50 μ
Product catalog summary
Specifications:
The document outlines the specifications for Single Crystal Diamond dies, which are available up to 50 μm. The tolerances achievable are dependent on using consistent measurement methods. The tightest tolerances can be achieved under special conditions, and further information can be obtained by contacting BALLOFFET.
Procedures:
It is suggested that any specific requirements or specifications beyond the provided data must be agreed upon with BALLOFFET before placing an order.
Data Summary:
The document includes a table with the following key data:
Materials:
The document specifies the use of Natural Single Crystal Diamond (NSCD) or Synthetic Single Crystal Diamond (SSCD).
The document outlines the specifications for Single Crystal Diamond dies, which are available up to 50 μm. The tolerances achievable are dependent on using consistent measurement methods. The tightest tolerances can be achieved under special conditions, and further information can be obtained by contacting BALLOFFET.
Procedures:
It is suggested that any specific requirements or specifications beyond the provided data must be agreed upon with BALLOFFET before placing an order.
Data Summary:
The document includes a table with the following key data:
- Size Range (mm): > 0.006 - 0.025, > 0.025 - 0.035, > 0.035 - 0.050
- Standard Tolerance (mm) for Soft Material: 0.2 - 0.5 Ø
- Standard Tolerance (mm) for Hard Material: 0.5 - 0.8 Ø
- Out of Roundness (μm): 0.3, 0.4, 0.5
- Standard Casing Ø x H (mm): 25 or 28 x 6 or 5 or 4
Materials:
The document specifies the use of Natural Single Crystal Diamond (NSCD) or Synthetic Single Crystal Diamond (SSCD).
See more
Catalog excerpts
Single Crystal Diamond dies up to 50 p Entrance NSCD : Natural Single Crystal Diamond or SSCD :Synthetic Single Crystal Diamond These tolerances can only be achieved by using the same measurement methods. Tightest Tolerance : This level of precision can be reached under special conditions. Please contact BALLOFFET for any further information. Above data are suggested by BALLOFFET. All other specifications or special requirement(s) must be agreed by BALLOFFET before placing an order.
Open the catalog to page 1All BALLOFFET S.A.S. catalogs and technical brochures
*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.