VM9-GA EASY IN-PROCESS GAUGING SYSTEM FOR GRINDING MACHINES VM9GA Easy is an in-process gauging system designed for simple and cost-effective applications. It is available in EASY2 and EASY3 versions. Both versions can measure, in a comparative mode, external diameters on smooth surfaces. Moreover, EASY3 allows the active and passive axial positioning. Compact and reliable, even in rugged environments Makes production stable and consistent with tight tolerances Analog display of the dimension, ergonomic keyboard with a selector and 2 buttons Compensates the grinding wheel wear 4 commands to control the feed rate (roughing, finishing, dwell, end of cycle) Can be installed on any type of grinding machine, both new and retrofitting Gauging range from 6 to 74 mm with an accuracy and a repeatability lower than 1 µm Does not require surveillance Analog output for passive axial positioning (F

Configuration of VM9-GA EASY2 gauging system for in-process measuring of smooth diameters

Configurations of the measuring system VM9-EASY3 for in-process gauging of smooth diameters and axial positioning (active and passive)

Configuration of the gauging amplifier VM9-GA EASY Multi-function keyboard Selector for parameters setup and operating mode Status signalling of the outputs to control the feed rate Led light of part program (IPG = diameter, FLAG = positioner) Led light of display range Analog display of dimension with auto-range Led light for a correct power source Dip switches for hardware and software configuration Technical data Versions Power source Display Measuring system Measuring unit Range factor Range for the IPG (diameter) Range of the Flag (axial position) Step for offset corrections Program for...