Bagela injection system Powerflow Accessories spare and wear parts Injection system Powerflow Designed to blow in optical fibre cable from dia.: 8-22mm into ducts of a dia. 32-50 mm. It is suitable for air- and water blowing. The drive chains are propelled by two low-wear and low-noise hydraulic motors which enable for- and backward movement of the cable. Only a few changes are necessary to change to different cable or pipe sizes. max. speed: 80 m/min required air flow: 10 m³/min required air pressure: 12 bar Control unit and Power Pack (125 bar / 15 L/min) essential! Order No. 111.200.00 Spare Parts and additional accessory Chain rail The chain rail, made from brass, supports the upper and lower drive chain. It is recommended to change the top / bottom rail at the same time. Order No. 111.220.00 Drive chain The drive unit constructed for cable dia. 8-22mm consists of two superimposed conveyor chains, provided with special rubber profile. The drive chains pull the cable from the drum into the blowing junction block wherefrom it is inserted into the tube by air or water pressure. It is recommended to change both drive chains at the same time. Order No. 111.222.00 Cable guide roller, horizontal The horizontal and vertical cable guide rollers lead and protect the fibre cable by the entry into the Powerflow. Order No. 111.224.00 Cable guide roller, vertical Order No. 111.225.00 Specifications are subject without notice. Output details are depending on use conditions

Bagela injection system Powerflow Accessories spare and wear parts Blowing Junction Block Consisting of a water or compressed air connection, the adapter for the pipe connection and the sealed cable guide. Adapter. The connection must adapt to the pipe size and is available in three dimensions. Order No. 111.230.00 111.231.00 111.232.00 Outer duct size 32 mm 40 mm 50 mm Cable guide for Blowing Junction Block The cable guide is to be inserted into the Blowing Junction Block Order No. 111.235.00 111.236.00 111.237.00 111.238.00 Cable sealing ring The sealing is to be inserted into the Cable guide...

Bagela injection system Powerflow Accessories spare and wear parts Y-Fitting To blow in a second cable, or micro pipes the Y-Fitting joins the old pipe with an intermediate pipe which is connected with the Powerflow. The protective pipe gets locked on both sides. Order No. 111.242.00 (without pipe and cable)) Automatic lubrication unit This pump is enables a precise dosing for constant lubrication and increases the laid length a lot. (for Powerflow und Multiflow) Order No. 111.244.00 (without can of cable slip oil) Uncoiling cage for fibre optic cable Is it not possible to insert the whole cable...