Bagela injection system Multiflow Accessories spare and wear parts Blow-in system Multiflow Designed to blow in multiple micro ducts or single large size cables into ducts with a dia. of 32 up to 50 mm. It is suitable for air- and water blowing. The drive chains are propelled by two low-wear and low-noise hydraulic motors which enable for- and backward movement of the cable. for fibre optic cable 8-22 mm. required air flow: 10 mVmin Control unit and Power Pack (125 bar/15 L/min) Spare Parts and additional accessory Chain rail The chain rail, made from brass, supports the upper and lower drive chain. It is recommended to change the top / bottom rail at Drive chain The drive unit consists of two superimposed conveyor chains and is provided with special rubber profile. Depending on the number and diameter of the Micro ducts appropriate chains are available. The drive chains pull the cable from the drum into the blowing junction block wherefrom it is inserted into the tube by air or water pressure. It is recommended to change the two drive chains Order No. 111.272.00 Chain for 7 duct bunch dia. 10 mm Order No. 111.273.00 Chain for 5/3 duct bunch dia. 10 mm Order No. 111.269.00 Chain for a single cable Cable guide roller, horizontal The horizontal cable guide rollers lead and protect the fibre cable by the entry into the Multiflow. Cable guide roller, vertical The vertical cable guide rollers lead and protect the fibre cable by the entry into the Multiflow. Specifications are subject without notice. Output details are depending on use conditions e-mail: [email protected]

Bagela injection system Multiflow Accessories spare and wear parts Blowing Junction Block for micro ducts Multiple micro ducts can be injected into protective ducts Cable guide „flex" for single cable Nylon-Applicator for micro ducts This applicator assistance for micro duct is fastened to the multi-flow and bundles the different pipes. The number of holes can vary. Please specify this when ordering. Sealing for micro ducts, 7 pieces The sealing is for the use of the blowing junction block with micro ducts. Many different combinations are possible regarding size and number of holes to micro ducts....

Bagela injection system Multiflow Accessories spare and wear parts Plug for micro ducts The plug is equipped with a o-ring for 100 % sealing. It is easy to mount with self cutting thread. It is available in other sizes. Please specify when ordering. Order No. Product name 111.296.00 Plug for 7 mm micro duct 111.297.00 Plug for 10 mm micro duct 111.298.00 Plug for 12 mm micro duct Sealing unit with manometer Laterally of the drum is the inner end of the duct where this unit is to be inserted and remain fixed during the injection A pressure loss will become visible at the manometer Overpressure...