Overhead-Line Winches KW 3F – KW 4F KW 3F at deconstruction of overhead lines Overhead line construction demands a maximum of reliability and operating precision of the winches.. To remove the fixing clamps of the insulators, the cable has to be lifted exactly to a point where the insulators are relieved from the cable load, but at the same time are no longer pressed against the fittings. If the operating lever is set to neutral or if pressing the emergency switch stops operation or if the engine stalls, the multiple disk brake will apply, preventing the rope tension from slackening. For lowering or pull on the brakes are released by hydraulic pressure. The overhead line winch of Type KW 3F is equipped with a electronic printer and may also be used for pulling underground cables without the need for any refitting. Serial outfit: Winch aggregate: • digital recording of pulling force (SD Card) adjustable pulling force delimiter, odometer with progress bar, speed indicator, thermal printer • elapsed hour counter • diesel engine with hydraulic gear • two single propelled, grooved capstan heads, storage drum with multi-disc brake and 500 m rope housing and chassis • lockable, sound proved ABS plastic housing • height adjustable chassis with overrunning brake, with automatic return, parking brake, supporting wheel and safety hitch, 12 V lightening system und TÜV (Technical Control Board) approval according to German road traffic regulations 100km/h. Aluminium rims • Central loading rail on top Additional outfit: Other type of engines, chassis, paintings and more rope if needed Static pull system, telescopic deflection boom Dimensions and weights may differ if extras are fitted Technical Data: Type Length Width Lift load Pulling Order No force Specifications are subject without notice. Output details are depending on use conditions.