BKS 1200
2Pages

Catalog excerpts

Pipe and Cable Pusher BKS 1200 Pipe Relining with the BKS 1200 If one neither can set up a tubing trailer nor a pipe renewal winch at the pit from lack of space, the solution is called: „BKS 1200 – Relining via Pipe pushing“ From, in the cable laying approved Cable pushers BKS 400 and BKS 800, we further developed a robust pipepushing device. The pushing strength was increased by the duplication of the number of the conical friction wheels and pressure wheels to 12 kN. The cable and pipe diameter, which can be pushed in, starts with 50mm and ends with 150mm. Is to be pushed only into one direction, it is sufficient to place the pipe pusher axially with downward gradient in front of the manhole and to fix it at the excavation wall. Specifications are subject without notice. Output details are depending on use conditions.

Open the catalog to page 1

Pipe and Cable Pusher BKS 1200 For cable and pipe diameter of 50-150mm If the old pipe or cable should be reconstructed on the whole line, the BKS 1200 is to be fixed between the two endings of the pipe in the manhole, so that one can push a 100 m in both directions Due to the population decrease, the increased environmental awareness and smaller losses in the future it showed up that smaller diameters have to be laid; which can be pushed in easily. Type BKS 1200 H BHA 200/10 Hydr. Power Pack. Hydraulichoses, 5 m Hydraulichoses, 10 m DriveLength Width Height engine mm mm mm 1300 450 650...

Open the catalog to page 2