Catalogs >
Badotherm Group >
B8 - block and bleed needle valve

B8 - block and bleed needle valve
2Pages

Catalog excerpts

technical specification model moc inlet outlet vent AISI316 1/2” NPT-F 1/2"NPT-f 5/16" x 24unf stem venting bonnet isolating bonnet stem packing - top side HS PTFE pressure temperature bracket holes 413 (6000) bar (psi) 240°C - design information .. self aligning metal seats flow diagram .. compact design .. non-rotating spindle tip .. metal seal between body and bonnet .. bonnet locking pins .. safety back seating T-bar .. full traceability of all materials .. 100% pressure tested dimensional drawings B8MF-front B8FF-front B8-side For technical data sheets and dimensional drawings please refer to our website www.badotherm.com 11/01/2008 rev 1 even block and bleed needle valve Badotherm model B8 is block and bleed needle valve specially designed for applications requiring bleeding or venting of the media. These types of needle valves are available with a variety of seat and seal materials. The valves are tested under pressure in the factory. This valve is available with a standard HS stem with a conical tip to ensure perfect alignment for a bubble tight shut-off B8 4.1.2. manifolds and valves

Open the catalog to page 1

B8 - additional information options and special execution at extra cost moc carbon steel, AISI316L, AISI304, Monel, Hastelloy inlet other sizes on request outlet other sizes on request stem SO gland packing PTFE glass filled, graphoil pressure up to 700 bar (10.000 psi) temperature up to 550°C handle with anti tamper facility with removable T-bar key plugs hexagon blind plugs support for brackets see bracket datasheet certificates material, test and NACE certificates cleaning for oxygen service design information pressure table metal seal HS type For technical data sheets and dimensional...

Open the catalog to page 2