Catalog excerpts
Solutions for the energy supply PLC-integrated grid measurement, protection and synchronization
Open the catalog to page 1MODULES FOR GRID MEASUREMENTPower Management The widespread use of electricity in all aspects of work and life offers a multitude of benefits, greater convenience and an improved quality of life. In order to ensure energy-optimized solutions in production, in buildings and in infrastructures, there is a growing need for these to be based on suitable measuring systems. At the same time, the maintenance of supply security requires integrated solutions for operating grids and the standards compliant management of generating units. Bachmann electronic offers both synergies through the direct...
Open the catalog to page 2The energy efficiency of machines and plants has significantly increased in importance. This requires devices for operational measurement at individual machines just as much as the overall total measurement of consumption at an entire site (energy monitoring). At the same time, supply security must also be ensured at all network levels even when conditions are continually more difficult. So-called grid codes have been defined by grid operators because of the mutual interaction that occurs between energy generating units and the electrical supply grid. These grid codes stipulate the required...
Open the catalog to page 3Higher level Communication (Utility, SCADA, Service, Virtual Power Plant Grid Protective Plant Master...) Control Control Tripping Plant Environment Lower level Communication (Other Generation Units, Protective Master, Switchgear,.) The grid measurement modules from Bach-mann electronic are designed in compliance with the signal modules of the M1 system. When they are mounted on main or substations of the modular PLC system, the most important characteristic values of measured three-phase systems are already available as channel values. There is no need to configure...
Open the catalog to page 4Grid modules from Bachmann electronic are fully integrated into the SolutionCenter. Configurations can be created efficiently and saved for reuse at a later time. An automated comparison of limit values set online with saved configuration files makes it easier to locate changes. Both the recorded channel values and the derived (calculated) variables are available at the user interface itself. Tabular, vectorial and time series displays facilitate development, commissioning and failure analysis. It is also possible to configure all measured and calculation values of the monitored three-phase...
Open the catalog to page 5Brochure Solutions for the energy supply EN | Subject to alterations without notice © 02/2017 by Bachmann electronic
Open the catalog to page 6All BACHMANN catalogs and technical brochures
-
Cantilever-Sensor (CLS)
2 Pages
-
MH200 Processor Modules
4 Pages
-
MC200 Processors
4 Pages
-
MX200 Processor Modules
4 Pages
-
Retrofit for wind energy
8 Pages
-
Redundancy Control
8 Pages
-
Web visualization
6 Pages
-
HMI systems
8 Pages
-
CHP Template
4 Pages
-
M1 control system
8 Pages
-
Wind Power SCADA
8 Pages
-
atvise® portal solutions
8 Pages
-
Engineering Software
42 Pages
-
industry application
60 Pages
-
HMI Portfolio
8 Pages
-
M1 automation system
8 Pages
-
Industry Bachmann & Cosateq
8 Pages
-
BHKW Template
4 Pages
-
System overview 2016
458 Pages
-
Marine
76 Pages
-
Industry
64 Pages
-
Energy
52 Pages
-
Wind power
68 Pages
-
Software_MMS-server
4 Pages
-
DNP3
5 Pages
-
Security
7 Pages
-
M-Target for Simulink
24 Pages
-
Safety Control
6 Pages
-
Safety for Wind
12 Pages
-
SolutionCenter
20 Pages
-
M1 webMI pro
6 Pages
-
Condition Based Monitoring
24 Pages
-
System overview 2015
406 Pages