1 Analog Signal Output CAN Controller (SAE J1939)
1 / 6Pages

• 1 analog signal output (voltage or current) • User selectable output range from +/-10V or +/-20 mA, including: 0-5V; 0-10V; +/-5V; +/-10V; 0-20mA; and 4-20 mA. • Embedded output voltage and current monitoring • 12V/24V/48VDC input power (nominal) with rugged surge protection • A CANopen® model is available as P/N: AX030521. • Rugged enclosure and connectors • Axiomatic Electronic Assistant for user configuration and programming • Distributed controls for power generation, co-generation, stationary power • Distributed controls for commercial vehicles, off-highway equipment, industrial equipment, etc. 1 Analog Signal Output CAN Controller (SAE J1939), P/N: AX030520 Axiomatic Electronic Assistant Configuration KIT, P/Ns: AX070502 or AX070506K Axiomatic Technologies Corporation 1445 Courtneypark Dr. E. Mississauga, ON Canada L5T 2E3 Tel. 1 905 602 9270 sales@axiomatic.com www.axiomatic.com

Block Diagram

Specifications are indicative and subject to change. Actual performance will vary depending on the application and operating conditions. Users should satisfy themselves that the product is suitable for use in the intended application. All our products carry a limited warranty against defects in material and workmanship. Please refer to our Warranty, Application Approvals/Limitations and Return Materials Process as described on https://www. axiomatic, com/service/. From a software perspective, the controller consists of a set of internal functional blocks, which can be individually...

Each functional block is absolutely independent and has its own set of programmable parameters, or setpoints. The setpoints can be viewed and changed through CAN using the Axiomatic Electronic Assistant. There are two types of the controller functional blocks. One type represents the controller hardware resources, for example the analog signal output block. The other type is purely logical – these functional blocks are included to program the user defined functionality of the controller. The number and functional diversity of these functional blocks are only limited by the system resources...

General Specifications Microcontroller Dimensional Drawing TOP VIEW SIDE VIEW MOUNTlNt; HOLES 2 MOUNTING HOLES TO SUIT #10 DR M4 HARDWARE

Mounting holes - The controller accepts 2 #10 or M4 screws. The CAN wiring is considered intrinsically safe. The power wires are not considered intrinsically safe and so in hazardous locations, they need to be located in conduit or conduit trays at all times. The module must be mounted in an enclosure in hazardous locations for this purpose. All field wiring should be suitable for the operating temperature range. Install the unit with appropriate space available for servicing and for adequate wire harness access (6 inches or 15 cm) and strain relief (12 inches or 30 cm). Network Termination...