Catalogs >
AUMA >
Service device PV 788 B

Service device PV 788 B
4Pages

Catalog excerpts

Product description

Actuator tester PV 788 B Application Actuator tester PV 788 B with remote control The parameters of AUMA actuators are normally factory-set to the values determined by the customer. Once the valve with the actuator has been installed at the site, the final setting and a test-run must be performed. With the actuator tester PV 788 B auma offers a professional device to carry out these field tests on all 3-phase powered electric actuators without integral controls. It can also be used for trouble-shooting, as well as for setting and testing actuators on valves at the valve-makers facilities....

Open the catalog to page 2

Actuator tester PV 788 B Multi-turn actuator SA AUMA NORM Measuring data recording or Remote control Typical application: Adjusting and testing of an electric multi-turn actuator, type SA Features Standard AUMA actuator tester PV 788 B is a table set in rigid aluminum/steel compound-housing including: ■ Measuring electronics ■ Liquid Crystal Display for analog values ■ LED’s for the limit/torque switch monitoring ■ Interface for external control /recording devices or remote control ■ AUMA multipin-connector for quick interconnection to actuator ■ Power cable with 32 A CE-plug. (3-Phase,...

Open the catalog to page 3

Multi-turn actuators SA 07.1 – SA 16.1 / SA 25.1 – SA 48.1 Torques from 10 to 32 000 Nm Output speeds from 4 to 180 rpm Multi-turn actuators SA/ SAR with controls AUMATIC Torques from 10 to 1 000 Nm Output speeds from 4 to 180 rpm Subject to change without notice. The product features and technical data provided do not express or imply any warranty. Linear thrust units LE with multi-turn actuators SA/ SAR Thrusts from 4 kN to 217 kN Strokes up to 500 mm Linear speeds from 20 to 360 mm/min Part-turn actuators SG 05.1 – SG 12.1 Torques from 100 to 1 200 Nm Operating times for 90° from 4 to...

Open the catalog to page 4