MELT PRESSURE and TEMPERATURE TRANSMITTER “Rigid Body Stem” MPT112 Strong Body Structure Against High Temperature Different Signal Output Options ZERO and SPAN Setting More durable with INCONEL 718 Alloy Membrane High Stability Accurate measurement Insensitive to Electrical Noise J Type Thermocouple (FE-CuNi) Long life Different Signal Options: 4-20mA, 0-10 VDC, 3.33 mV / V They are used to measure the pressure and temperature of hot fluids in the plastics, rubber, food, etc. sectors. In this way, the quality of the production is higher and damage due to the high pressure i s provid e d to the machine. The MPT series are low cost and high quality products. The MPT makes mercury measurements in the series. In products in the health and food sector, oily measurements are made. ALP Series Digital Measuring and Control Devices are also available with the measured value being displayed. Technical Specification One thing to note during installation is that the extreme part of the sensor, which is the pressure measuring part, is not damaged during installation. If this part is damaged, the sensor will not measure. Maximum Pressure Model Body Model Included In Delivery 1 Connector / 4 Pin Female Socket Output Signal V : 0-10 VDC Analog Output

3,33mV/V or 2.00mV/V Analog Output A : + Signal Out B : - Signal Out C : + Supply Voltage +10VDC D : - Supply Voltage GND C : + Supply Voltage +24VDC D : - Supply Voltage GND E,F : Calibration ( FS %80 ) Z : Zero S : Span \ : + Supply Voltage 24 VDC B : - Signal(4-20mA Output) E,F : Calibration ( FS %80 ) Z : Zero S : Span Mechanical Dimension