APPLIED SENSING TECHNOLOGIES % Oxygen Sensor Model: SRX-CT17A SRX-R17A Oxygen Sensor is a galvanic type micro fuel cell specific to oxygen. This sensor is specifically designed for measurement of O2 in auto exhaust. Proprietary electolyte formulation ensures full utilization of Pb anode, thus providing longer life without signal drift and minimizing periodic calibration requirement. Sensor is designed, developed and manufactured in the USA. SRX-CT17A replaces: Teledyne R-17A Envitec 00A100-1 City Technology A03 Sensor Technology Measuring Range Signal Output¹ Response Time T90 Accuracy ² Drift ² Linearity Repeatability Temperature Coefficient Operating Temperature Recommended Storage Temperature Recommended Flow Rate Humidity Non-Condensing2 Expected Life³ Recommended Storage Warranty4 Electrical Connections - Mini Jack .141” Front Galvanic Type Micro Fuel Cell 0 to 100 Percent Oxygen 7-13 mV 6 seconds +/- 1% of signal < 2% +/- 1% +/- 0.5% NONE - signal output is temperature compensated 0 to 40°C 5 to 35°C - Intermittent exposure upto 50o C acceptable 0.5 - 5 SCFH 0 - 98% RH 36 months 6 months 12 months Tip - Negative, Sleeve - Positive M16 x 1 Thread Note: SRX-CT17A is packaged in a polyethylene bag . Do not expose sensor to temperatures above 50o C for extended period of time. Failure to do so may have negative impact on its performance and life. 1. Signal Output measured in air at 25°C, atmospheric pressure. 2. At constant temperature and pressure; for each %RH increase, O2 signal will drop equivalent to 0.03% oxygen. 3. At ambient temperature and pressure, and oxygen content less than 21%. 4. AST warrants the sensor for 12 months to be free from defects in materials and workmanship. AST will not be held liable for sensor damaged due to customer neglect. * Specifications are validated during design and are subject to change without notice.