MEMS Capacitive Accelerometer ► Triaxial ► MF (Medium Frequency; DC to 2,5kHz) ► 8 or 12 Wire System ► Amplified Output ► Aluminium Housing / Features ► Range: ±2g to ±200g ► DC Response ► Gas Damped ► Excellent Bias and Scale Factor Stability ► Low Power Consumption ► Differential Mode Options ► Customised Cable Length ► Customised Connector ► TEDS Module Applications ► Structural Monitoring and Testing ► Endurance Testing ► Brake Test ► Vibration Monitoring ► Civil Engineering ► Modal Analysis ► Vehicle Testing ► Automotive Ride Quality & Comfort ► Railway Engineering ► Flutter Test ► Seismic Monitoring Capacitive MEMS Technology ASC's Medium Frequency (MFseries) capacitive accelerometers are based on the capacitive sensing technology and produce an analog voltage proportional to the input acceleration. The accelerometers can measure both static (gravity) and dynamic accelerations. ASC's MF series can be used for very low to medium frequency vibration measurements from 0Hz to 2.5kHz. The MF series features a MEMS sensor element where the seismic mass is connected Description The models ASC 5421 and ASC 5425 have been developed for the demanding requirements of different applications. The highly robust housing an the connecting cables are suitable for the rough application areas in automotive, train, military and so on. These ASC accelerometers benefit from the high stability of the chip technology with a low bias and an excellent scale factor temperature coefficient. The ASC 5421 and ASC 5425 are fully compensated over a wide temperature range and are factory calibrated. As capacitive technology is used, extremely small measuring ranges are possible. The amplified output is easy to use with a data acquisition unit. The signal is independent from the power between +8VDC to +30VDC. A very high flexible and rugged cable provides a simple mounting. ASC 5421 and ASC 5425 are equipped with 6 meter cable as standard. ASC GmbH ■ Advanced Sensors Calibration ■ Ledererstra&e 10 ■ 85276 Pfaffenhofen ■ Germany ■ Tel. +49 (0) 8441 786 547 -0 ■

Typical Specifications DYNAMIC Range (±g) 1 2 5 10 30 50 100 200" Shock limit ±g 5000 (0.15ms, half-sine) ELECTRICAL Excitation voltage V DC 8-30 Zero acceleration output ±mV 100 30 30 30 30 30 30 30 Isolation Case Isolated Residual / Broadband noise (±5% frequency range) |jV 180 180 180 700 800 800 800 800 ENVIRONMENTAL Thermal sensitivity shift %/°C 0.01 Thermal zero shift mg/°C 0.05 0.1 0.25 0.5 1.5 2.5 5 10 Operating temperature range °C -40°C to +100°C Storage temperature...

FACTORY CALIBRATION (SUPPLIED WITH THE SENSOR) Range 1g 2g and 5g 10g 30g 50g to 200g CALIBRATION DIN ISO 17025 (ORDER SEPARATELY) Range 1g 2g and 5g 10g 30g 50g to 200g Cable Code /Pin Configuration 8-wiring-System Red Supply + Black Supply - White/Violet Signal - White/Grey Signal - White Signal - Black/Violet Supply - White/Violet Signal - Black/Grey Supply - White/Grey Signal - Black Supply - White Signal - Model number Range (Ex. 050 is 50g) Cable length (meters) Connector & Pinout ASC GmbH ■ Advanced Sensors Calibration...