MEMS Capacitive Accelerometer ► Uniaxial ► 4 Wire System ► Amplified Output ► Made in Germany Features ► Range: ±1g to ±200g ► DC Response ► Gas Damped ► Excellent Bias and Scale Factor Stability ► Low Power Consumption ► Single Ended Mode Options ► Customised Cable Length ► Customised Connector ► TEDS Module Applications ► Structural Monitoring and Testing ► Endurance Testing ► Brake Test ► Vibration Monitoring ► Civil Engineering ► Modal Analysis ► Vehicle Testing ► Automotive Ride Quality & Comfort ► Railway Engineering ► Flutter Test Capacitive MEMS Technology The accelerometers are based on a capacitive MEMS technology and can be used in a low frequency response up from 0Hz. Inside the sensor element, the seismic mass is connected with two conductive capacitor plates. If the seismic mass oscillates between the two capacitor plates the capacitance will change. This capacitance change is converted via an ASIC (Application Specific Integrated Circuit) into an analog signal. Description The model ASC 4221 has been developed for the demanding requirements of different applications. The highly robust housing and the connecting cables are suitable for the rough application areas in automotive, train, military and so on. These ASC accelerometers benefit from the high stability of the chip technology with a low bias and an excellent scale factor temperature coefficient. The ASC 4221 is fully compensated over a wide temperature range and are factory calibrated. As capacitive technology is used, extremely small measuring ranges are possible. The amplified output is easy to use with a data acquisition unit. The signal is independent from the power between +8VDC to +30VDC. A very high flexible and rugged cable provides a simple mounting. The ASC 4221 is equipped with 6 meter cable as standard. ASC GmbH ■ Advanced Sensors Calibration ■ Ledererstra&e 10 ■ 85276 Pfaffenhofen ■ Germany ■ Tel. +49 (0) 8441 786 547 -0 ■

Typical Specifications DYNAMIC Range (±g) 1 2 5 10 30 50 100 200" Shock limit ±g 5000 (0.15ms, half-sine) ELECTRICAL Excitation voltage V DC 8-30 Zero acceleration output ±mV 100 30 30 30 30 30 30 30 Isolation Case Isolated Residual / Broadband noise (±5% frequency range) |jV 180 180 180 700 800 800 800 800 ENVIRONMENTAL Thermal sensitivity shift %/°C 0.01 Thermal zero shift mg/°C 0.05 0.1 0.25 0.5 1.5 2.5 5 10 Operating temperature range °C -40°C to +100°C Storage temperature...

FACTORY CALIBRATION (SUPPLIED WITH THE SENSOR) Range 1g 2g and 5g 10g 30g 50g to 200g CALIBRATION DIN ISO 17025 (ORDER SEPARATELY) Range 1g 2g and 5g 10g 30g 50g to 200g Cable Code/Pin Configuration Red Supply + Black Supply -Green Signal + White Signal -ORDERING INFORMATION ASC 4221 002 6 A Model number Range (Ex. 050 is 50g) Cable length (meters) Connector & Pinout ASC GmbH ■ Advanced Sensors Calibration LedererstraSe 10 ■ 85276 Pfaffenhofen ■ Germany ■ Tel. +49 (0) 8441 786 547 -0 ■ [email protected] All data, information, statements,...