MEMS Capacitive Accelerometer ► Uniaxial ► Ultra Low Noise (LN) ► High g-Range ► 4 Wire System ► Amplified Output ► Made in Germany Features ► Range: ±2g to ±400g ► DC Response ► High Shock Resistance ► Gas Damped ► Excellent Bias and Scale Factor Stability ► Differential Mode Options ► Customised Cable Length ► Customised Connector ► TEDS Module Applications ► Structural Monitoring and Testing ► Endurance Testing ► Brake Test ► Vibration Monitoring ► Civil Engineering ► Modal Analysis ► Vehicle Testing ► Automotive Ride Quality & Comfort ► Railway Engineering ► Flutter Test Capacitive MEMS Technology The accelerometers are based on a capacitive MEMS technology and can be used in a low frequency response up from 0Hz. Inside the sensor element, the seismic mass is connected with two conductive capacitor plates. If the seismic mass oscillates between the two capacitor plates the capacitance will change. This capacitance change is converted via an ASIC (Application Specific Integrated Circuit) into an analog signal. Description The model ASC 3511LN is an uniaxial accelerometer based on capacitive technology. It is over a wide temperature range fully compensated an factory calibrated. The sensor has been developed specifically for measuring relatively low level accelerations, as required in the aerospace or automotive sector, for example. The amplified output is useable easy on a data acquisition unit. The signal is independent from the power between +8VDC to +30VDC. The package is hard anodized aluminium that is rugged for automotive, industrial and military applications. With the Cube-Form there are more possibilities for mounting. A very high flexible and rugged cable provides a simple mounting on delicate positions. The model ASC 3511LN is a Low Noise version which has a much lower noise and a better frequency response. The four wire output can be connected to all data management systems. ASC GmbH ■ Advanced Sensors Calibration ■ LedererstraBe 10 ■ 85276 Pfaffenhofen ■ Germany ■ Tel. +49 (0) 8441 786 547 -0 ■

Typical Specifications DYNAMIC Range (±g) 2 5 10 25 50 100 200 400" ELECTRICAL Excitation voltage V DC 8-30 Zero acceleration output ±mV 150 150 80 80 80 80 80 80 Isolation Case Isolated Residual / Broadband noise (±5% frequency range) |jV 100 60 70 90 100 100 125 125 ENVIRONMENTAL Thermal sensitivity shift %/°C 0.015 Thermal zero shift mg/°C 0.15 0.4 0.75 2 4 7.5 15 30 Operating temperature range °C -40°C to +100°C Storage temperature range °C -55°C to +125°C Humidity/Sealing...

FACTORY CALIBRATION (SUPPLIED WITH THE SENSOR) Range 2g and 5g 10g 25g 50g and 100g 200g and 400g CALIBRATION DIN ISO 17025 (ORDER SEPARATELY) Range 2g and 5g 10g 25g 50g and 100g 200g and 400g Cable Code/Pin Configuration Red Supply + Black Supply -Green Signal + White Signal -ORDERING INFORMATION 3511LN 002 6 A Model number Range (Ex. 050 is 50g) Cable length (meters) Connector & Pinout ASC GmbH ■ Advanced Sensors Calibration LedererstraSe 10 ■ 85276 Pfaffenhofen ■ Germany ■ Tel. +49 (0) 8441 786 547 -0 ■ [email protected] All data, information,...