The injection system for variable and efficient fixing. BUILDING MATERIALS0 Chemical fixings Injection mortar FIS PM 360S APPROVALS Approved for: ▪ Concrete C.20/25 – C50/60, cracked and non-cracked Also suitable for: ▪ Natural stone with dense structure ADVANTAGES APPLICATIONS FUNCTIONING ▪ The variability in the anchorage depth and building component thickness enables optimal dimensioning for economic anchorage. ▪ Allowed in hammer- and diamonddrilled drill holes for maximum safety in planning and processing. ▪ With just three power sleeve dimensions and the fischer FIS A threaded rods, an entire M10/M12/M16 assortment can be covered with the lowest inventory cost. ▪ Savings in assembly time through the special mortar which is permitted for water-filled drill holes. ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ The Powerbond System consists of the injection mortar FIS PM based on styrene-free vinyl ester, the stainless steel sleeve Power Sleeve FIS PS and the threaded rod FIS A. ▪ Powerbond is suitable for prepositioned and push-through installation. ▪ The sleeve FIS PS is placed in the drill hole and filled bubble-free with injection mortar FIS PM from the drill hole base. ▪ The threaded rod is set manually, by lightly rotating it until it reaches the drill hole base. ▪ The mortar fully bonds the sleeve and threaded rod with the drill hole wall and seals the drill hole. http://www.fischerwerke.de/en/ - 16/07/2012 Guard rails Consoles Steel consoles Timber construction High rack warehouse Silos Conveyor belt Signs and signal installation Machines 1

Injection mortar FIS PM 360S Chemical fixings TECHNICAL DATA Approval Injection mortar FIS PM 360S Languages on the cartridge Article name FIS PM 360 S Art.-No. 517874 ■ D FIS PM 360 S 518600 ■ D, F, NL FIS PM 360 S 518785 ■ GB, E, P http://www.fischerwerke.de/en/ - 16/07/2012 Contents 1 cartridge 360 ml, 2 x static mixer FIS S 1 cartridge 360 ml, 2 x static mixer FIS S 1 cartridge 360 ml, 2 x static mixer FIS S 2

Injection system Powerbond with threaded rod FIS A (property class 8.8) Highest permissible loads for a single anchor1161 in concrete C20/2 54: For the design the complete approval ETA - 1 2/01 60 has to be considered The partial safety factors for material resistance as regulated in the approval as well as a partial safety factor for load actions of yL = 1,4 are considered. As an single anchor counts e.g. an anchor with a spacing s > 3 x hef and an edge distance c > 1,5 x hef. Minimum possible axial spacings resp. edge distance while reducing the permissible load. For combinations of tensile...