C Programmable Remote I/O Module Features • 4 x Opto-isolated digital inputs • 2 x Relay outputs • 4 x Isolation Analog inputs • 2 x Maxim 1-Wire interface • 1 x 10/100Mbps Ethernet interface • 1 x Isolation RS-485 port, 1 Serial Console / RS-232 port • 1 x microSD card interface • Support lwIP and BSD socket library • Support tiny web server • Windows configuration utility included • Toolchain: Atmel Studio H/W Specifications CPU / Memory • CPU: Atmel SAM4E16E Cortex M4 SoC 120MHz • Memory: 128KB SRAM, 1MB Flash inside SoC 128KB SRAM, 2MB Flash on board via SPI expansion Network Interface • Type: 1 x 10/100 Mbps Ethernet, RJ45 connector • Protection: 1.5KV magnetic isolation Serial Ports • Serial Console / RS-232 x 1 • RS-485 1500Vrms isolated x 1 Isolated Analog Input • No. of Channel: 4 • Input Type: Differential input • Input Mode: Current / Voltage • Resolution: 16-bit • Input Range: Unipolar: 0~150 mV, 0~500 mV, 0~1V, 0~5V, 0~10V Bipolar:+/-150 mV, +/-500 mV, +/-1V, +/-5V, +/-10V Current: 0~20mA • Input Impedance: 20M Ohm (voltage), 120 Ohm (current) • Accuracy: +/-0.1% FSR • Isolated: 1500Vrms Isolation Digital Input • No. of Channels: 4 • Isolation protection: 2500Vrms • Logical High: 5~24VDC • Logical Low: 0~1.5VDC • LED indicator: Yes Relay Output • No. of Channels: 2 • Contact Rating: 30VDC@1A or [email protected] • LED Indicator: Yes Maxim 1-Wire Interface • No. of Channels: 2 • Connector: 3-pin terminal block (VDD, DQ, GND) General • Power Input: 9~48VDC • Operating Temperature: 0~70°C • Dimension(WxLxH): 115.7x121.5x43mm (4.56"x4.78"x1.69") • Weight: 242g (0.53lb) • Installation: DIN-rail mounting • Mass Storage: Miro-SD socket inside x1 Usor_main() C/C++ 1-Wire Analog Input Ordering Information • RIO-2014PG C Programmable Remote I/O Module • CBL-F10M9-20 (91-0P9M9-001) Console Cable (10Pin Header to DB9 Male, 20cm) • DS18B20 (91-6DS18-001) Programmable Resolution 1-wire Digital Thermometer • PWR-12V-1A (31-62100-000) 110~240VAC to 12VDC 1A Power Adapter