Measuring Transducers and Signal Unit for DIN-rail mounting Wiring diagram Wiring diagram Wiring diagram Wiring diagram Multiple-Supply Unit serves for feeding of two-wire transmitter with direct voltage by output The single circuits are physically seperated to each other and are electronic fused to short circuit. Supply voltage: Pulsation factor: Signal circuit: approx. 30 mA by short circuit Supply voltage 2 x 18 V, resp. 4 x 18 V, non-stabbilized Signal circuit 2x 4...20 mA, resp. 4 x 4...20 mA Extra charges Line voltage 24 V 50 c/s serves for physically isolation and synchronous amplification or transducing of electrical standard signals. Incorporated supply voltage for supply of a two-wire measuring transmitter. Output signals are both a voltage 0...10 Vand a current signal 0/4...20 mA. Both output signals are related to their common negative pole. Supply voltage: approx. 18 V, non-stabilized, max. 25mA Voltage output: 0...10 V, short-circuit proof, max. 5 mA Current output: 0/4...20 mA, max. load 500 Q Physically isolation: between input-output-line voltage with isolation between input - output - line voltage Supply voltage: approx. 18 V, non-stabilized Extra charges Line voltage 24 V 50 c/s serves for controlling measuring values which are represented as electrical currents. A potential-free contact is switched when the corresponding presetted nominal value either is fallen short (min.- function) or is exceeded (max. function). Hysteresis and time delay are adjustable inside the unit by trimmers. Supply voltage: Nominal value: Time delay: Error limits Accuracy of nominal value setting: Temperature drift: Poti with scales 0...100 % Output: two potential-free contact, 250 V, 8 A corrections reserved