Arthur Grillo MAGNETIC-INDUCTIV FLOWMETER MID □ Magnetic inductive transducers □ Large measurement ratio □ Low pressure drop □ Lining Teflon PTFE, max. Temperature 130 ° C □ Output 4... 20 mA, flow linear □ Accuracy 0.6% of reading □ Flanged to DIN 2501 □ Power supply 230 Vac Advantage: linear outputs-signal, high meassuring ratio, low pressure-loss Conditions for use: Minimum fluid conductivity: 5 mS/cm. This is given to water and glycol-water mixtures normally. Temperature max. 130 °C, preferably mounting the transmitter in the return line Magnetic-inductiver flowmeter MID Teflon-lined PTFE, max. temperature 130 °C Connection: flanges according to DIN 2501 p.37.2 PN40/PN16/PN10 Supply voltage: 230 Vac Output: 4...20 mA, linear flow, accuracy ± 0.6% of rate Nominal diameter DN32 PN40 Span 0...29 m3/h, factory-adjusted 0...10 m3/h Nominal diameter DN40 PN40 Span 0...45,2 irP/h, factory-adjusted 0...10 irP/h Nominal diameter DN50 PN40 span 0...70.7 irP/h, factory-adjusted 0...20 irP/h Nominal diameter DN65 PN16 Span 0...119,5 irP/h, factory-adjusted 0...50 irP/h Nominal diameter DN80 PN16 Span 0...181 irP/h, factory-adjusted 0...50 irP/h Nominal diameter DN100 PN16 span 0...282,7 irP/h, factory-adjusted 0...70 irP/h Nominal diameter DN125 PN16 Span 0...441,8 irP/h, factory-adjusted 0...100 irP/h I Nominal diameter DN150 PN16 Span 0...636,2 irP/h, factory-adjusted 0...150 irP/h Nominal diameter DN200 PN10 Span 0...1131 irP/h, factory-adjusted 0...250 irP/h Arthur Grillo GmbH • Am Sandbach 7 • 40878 Ratingen • phone 0 21 02 - 47 10 22 • fax 0 21 02 - 47 58 82 www.grillo-messgeraete.de/en • Email: [email protected] • web shop: www.sensor-store.de