Catalog excerpts
I/O modules via CanBus allow building of a remotely controlled system for the exchange of digital data using a screened single-pair cable. This decreases the amount of cabling needed and the operating costs, without penalizing system performance. SU modules' compatibility with the CANOpen fieldbus enables them to be connected to other modules and systems compliant with the same standard, which are easily found on the market. The CANOpen module is small and quickly attached: it can be placed on the machine and connected to the electrical control panel with a single cable.
Open the catalog to page 1
CHARACTERISTICS DESCRIPTION NOTES FIELDBUS CanBus CANOpen 2.0b POWER SUPPLY REQUIREMENTS Standard in slave mode Power supply voltage 24 Vdc ±20% DIGITAL INPUT & OUTPUT CONFIGURATION 32 digital inputs Opto-isolated 24Vdc PNP 64 digital inputs Opto-isolated 24Vdc PNP Opto-isolated 24Vdc PNP 16 digital inputs + 16 digital outputs 1.8 Amp/output, Max 4.4 Amps on each group of 4 outputs Protected against short-circuits, over-current, overheating, over-voltage and power voltage inversion Opto-isolated 24Vdc PNP 32 digital inputs + 32 digital outputs 1.8 Amp/output, Max 4.4 Amps on each group of 4...
Open the catalog to page 2All Arteco Motion Tech catalogs and technical brochures
-
Arteco 50002 Pages
-
Arteco 30002 Pages
-
Arteco Face Recognition2 Pages
-
Arteco LPR2 Pages
-
Arteco Extreme2 Pages
-
Arteco Open Connector2 Pages
-
Arteco Contact ID2 Pages
-
Arteco Events Analytics2 Pages
-
Arteco Next2 Pages
-
Arteco eMotion Datasheet2 Pages
-
Arteco Pure Datasheet2 Pages
-
ETHERNET REMOTE I/O2 Pages
-
ISaGRAF2 Pages
-
Serial I/O module2 Pages
-
CANOpen Axis Controller2 Pages
-
BUS I/O module2 Pages
-
SU310-PLC2 Pages
-
SU-PLC2 Pages
-
CND512 Pages
-
SU112-TOUCH2 Pages
-
SU1122 Pages
-
SU2102 Pages