Catalogs >
APS Novastar >
GF-120HT Reflow Oven

GF-120HT Reflow Oven
4Pages

Catalog excerpts

Model GF-120-HT • 3 vertical heating zones plus cooling zone • Low mass 12" wide stainless steel conveyor • Easy lift clamshell design compo Model GF-120-HT with 12" wide conveyor and 41" heated tunnel length shown with optional enclosed stand TM HORIZONTAL CONVECTION DDM Novastar ovens are used for reflowing solder on PC boards, curing, drying and thermal cycling. Our patented** Horizontal Convection TM system provides the most accurate, most consistent and most repeatable profiles. Air is circulated horizontally in one direction above the board, and in the opposite direction below...

Open the catalog to page 2

with revolutionary Horizontal Convection Model 2000-HT with 20" wide conveyor and 72” heated tunnel length shown with PC interface option Model 1800-HT with 18” wide conveyor and 50” heated tunnel length, shown with edge conveyor and PC interface options Model 1800-HT • 4 vertical heating zones plus cooling zone • Low mass 18" wide stainless steel conveyor Easy lift clamshell design with gas strut assist Status light tower Model 2000-HT • 6 vertical heating zones plus cooling zone • Low mass 20" wide stainless steel conveyor The ProcessSentry TM microprocessor control is the brain of DDM...

Open the catalog to page 3

MACHINE SPECIFICATIONS Theoretical Reflow Profile Typical Profile for Model 1200 (3 Vertical Heating Zones) Typical Reflow Profile for Model 2000 (7 Vertical Heating Zones) t0-t1 PREHEAT *All DDM Novastar reflow ovens are covered under patent 6,936,793 **Add 4 inches to each end for edge conveyor ***Other electrical configurations available tUp to 4” (102 mm) special application tunnel height 165 Boro Line Road • King of Prussia, PA 19406 • USA Phone: 610-337-3050 • Fax: 610-337-3054 • www.ddmnovastar.com • info@ddmnovastar.com © 2012 DDM Novastar Inc. Prices and Specifications subject...

Open the catalog to page 4