ATPLUG SERIES
2Pages

Catalog excerpts

DATA SHEET > POWER SUPPLY PROTECTION FOR AREAS WITH LOW OVERVOLTAGES > ATPLUG SERIES > ATPLUG Electrical plug-in protector > AT-9601 ATPLUG: Single-phase line protection for Schuko type plug. It contains effective protection against transient overvoltages for single-phase power supply lines. Tight protection according to the cascade protection recommended in the Spanish Low Voltage Regulations (REBT ITC23). This SPD is plugged directly in the same socket as the load to be protected. Its installation is simple and intuitive, complementing the load to be protected regardless of where it is placed. Type 3 protector according to the standard EN 61643-11 and GUÍA-BT-23 from the REBT. Suitable for categories I, II, III and IV equipment according to the REBT. > Can be coordinated with other ATSHOCK, ATSHIELD, ATSUB and ATCOVER series protectors. > Short response time. > INSTALLATION To be installed in parallel with the loads plugged to the charges that want to be protected. Its use is recommended in systems where equipment sensitive to overvoltages is installed (computers, printers, servers etc.) and always coordinated with type 1 or 2 protectors. > Do not produce deflagration. > No interruptions in power supply at any time. > Thermodynamic control device and visual alarm. When the protector is OK, the green light is illuminated. When there is a failure, the light turns off. ATPLUG series protectors have been tested in official and independent laboratories, obtaining their characteristics according to relevant standards (shown in the table). Connection to earth is a must. Earthing in the whole installation must be bonded either directly or by a spark gap and resistance should be lower than 10 Ω. If the indications on this datasheet are not fulfilled during use or installation of the protectors, the protection provided by this device could be compromised. Aplicaciones Tecnológicas S.A. - Parque Tecnológico de Valencia - Nicolás Copérnico, 4 - 46980 Paterna (Valencia), Spain T +34 961 318 250 - F +34 961 318 206 - atsa@at3w.com - www.at3w.

Open the catalog to page 1

DATA SHEET APLICACIONES TECNOLOGICAS > POWER SUPPLY PROTECTION FOR AREAS WITH LOW OVERVOLTAGES > ATPLUG SERIES > DIMENSIONS (MM) Aplicaciones Tecnologicas S.A. - Parque Tecnologico de Valencia - Nicolas Copernico, 4 - 46980 Paterna (Valencia), Spain T +34 961 318 250 - F +34 961 318 206 - atsa@at3w.com - www.at3w.com

Open the catalog to page 2