DATA SHEET > PROTECTION FOR DATA AND TELECOMMUNICATION LINES > ATLAN 12/8/4 CAT6 SERIES > ATLAN 12/8/4 CAT6 Protector for computer network rack with category 6 wiring > AT-2217 ATLAN 4 CAT6: protector in rack for 4 network category 6 lines. > AT-2212 ATLAN 8 CAT6: protector in rack for 8 network category 6 lines. > AT-2211 ATLAN 12 CAT6: protector in rack for 12 network category 6 lines. > AT-2226 ATLAN 4 CAT6 POE: protector in rack for 4 POE (Power Over Ethernet) network category 6 lines. > AT-2227 ATLAN 8 CAT6 POE: protector in rack for 8 POE (Power Over Ethernet) network category 6 lines. > AT-2228 ATLAN 12 CAT6 POE: protector in rack for 12 POE (Power Over Ethernet) network category 6 lines. ATLAN protectors are especially designed to prevent failures in data transfer between equipment within the same network. They protect the electronic circuit inputs of the network cards against damage due to transient currents. ATLAN 12/8/4 is an SPD for 12, 8 and 4 protected lines, with four pairs protected per line. This is done with a printed circuit board with crimped input cable and RJ45 output connector, able to withstand current up to 2 kA for each line and with a transfer speed of 250 MHz. It is especially designed to be inserted into a rack and protect computer network distribution cabinets. Due to its high transfer speed, it is suitable for networks transferring a large amount of data (servers, workstations, graphic stations etc.) If there are two pieces of equipment located in separate buildings but linked together, the protection must be installed on both sides of the line. Includes 50 cm category 6 output cable already crimped. The ATLAN 12/8/4 CAT6 protector has been tested and certified in official and independent laboratories, obtaining their characteristics according to relevant standards (shown in the table). Protection should be installed as close as possible to the equipment. In this particular case, we’re talking about switches and hubs. The recommended procedure for installation is the following: 1 Screw the protectors onto the 19” rack for computer network distribution. 2 Run the network distribution lines from the hub or switch to the protector. 3 Bond the rack ground to the ground marked in the box chassis. Connection to earth is a must. Earthing in the whole installation must be bonded either directly or by a spark gap and resistance should be lower than 10 Ω. If the indications on this datasheet are not fulfilled during use or installation of the protectors, the protection provided by this device could be compromised. Cable from network Aplicaciones Tecnológicas S.A. - Parque Tecnológico de Valencia - Nicolás Copérnico, 4 - 46980 Paterna (Valencia), Spain T +34 961 318 250 - F +34 961 318 206 - [email protected] - www.at

DATA SHEET > PROTECTION FOR DATA AND TELECOMMUNICATION LINES > ATLAN 12/8/4 CAT6 SERIES > TECHNICAL DATASHEET ATLAN 4 CAT6 AT-2217 Maximum transfer speed: Nominal voltage: Maximum continuous operating voltage: Protection level: Maximum operating current: Series resistance: Response time: Nominal discharge current for line C2 4 kV (1.2/50 μs) / 2 kA (8/20 μs): Working temperature: Protector location: Enclosure material: Enclosure protection: Input / output connector: Earthing system: Certificated tests according to: UNE-EN 61643-21 Relevant standards: UNE 21186, NF C 17-102, IEC 62305 > AT-2222...