video corpo

Chemical Protective Suits Instructions for Use TRELLCHEM ® VPS FLASH
44Pages

{{requestButtons}}

Catalog excerpts

Chemical Protective Suits Instructions for Use TRELLCHEM ®  VPS FLASH - 1

Chemical Protective Suits Instructions for Use TRELLCHEM® VPS FLASH This manual may only be removed from the suit by the end user.

Open the catalog to page 1
Chemical Protective Suits Instructions for Use TRELLCHEM ®  VPS FLASH - 5

• These instructions for use (IFU) are valid only for Trellchem® VPS Flash, totally encapsulating/Level A version. • The suit may only be used by trained personnel who are familiar with the contents of this IFU. • Use the suit only for the purposes specified herein. • Do not use a damaged or incomplete suit, and do not modify the suit. • For repair and maintenance, only use genuine Trellchem spare parts, or the function may be impaired. 1.1 Definitions of icons The following icons are used in this IFU to highlight the user on situations or actions that need special attention not to risk the...

Open the catalog to page 5
Chemical Protective Suits Instructions for Use TRELLCHEM ®  VPS FLASH - 6

TreUchem VPS Flash is • A totally encapsulating/Level A, gastight chemical protective suit • Intended for use with a self-contained breathing apparatus (SCBA) and a full-face mask* • Single-skin, i.e. no overcover is needed • Re-usable The suit is fitted with: • Booties/sewn-in socks • Replaceable gloves • Visor which is available in two optional sizes; CV (standard) or VP1 (larger) • Suit ventilation upon request The following accessories are delivered with every suit: • Cotton comfort inner gloves • Silicone coated oversocks • Maintenance kit for zipper and Bayonet ring system • Extra...

Open the catalog to page 6
Chemical Protective Suits Instructions for Use TRELLCHEM ®  VPS FLASH - 7

3. Approvals 3.1 NFPA Trellchem VPS Flash is certified to NFPA 1991:2016, “Standard on vapor-protective ensembles for hazardous materials emergencies”, including the Optional Chemical Flash Fire protection requirements and the Optional Liquefied Gas protective requirements. Trellchem VPS Flash is certified by SEI (Safety Equipment Institute, USA). Cert. Mod. (NFPA 1991, 2016 edition) Upon certification, an SCBA type Scott AV3000 and an MSA Ultra Elite mask were used, but other SCBAs may also be used with the suit. 3.1.1 Approved accessories Boots: • Onguard Hazmax #87015 or #87012 boot •...

Open the catalog to page 7
Chemical Protective Suits Instructions for Use TRELLCHEM ®  VPS FLASH - 8

4. Proper use Proper use within the USA is consistent with NFPA 1500, Standard on Fire Department Occupational Safety and Health Program, and 29 CFR 1910.132, Personal Protective Equipment. Users in other countries are advised to consult national or other applicable personal protective equipment regulations. 4.1 Intended use The suit protects against chemicals in gaseous, liquid, aerosol and solid form. It also protects against infectious agents, i.e. bacteria, virus and fungi, and against radioactive particles. 4.2 Limitations of use • Avoid extensive heat and open flames. • The suit is...

Open the catalog to page 8
Chemical Protective Suits Instructions for Use TRELLCHEM ®  VPS FLASH - 9

5. Pre-use Before use, make sure: • The suit is pressure tested/leak tight and undamaged, see chapter 9 • The suit and gloves have the correct size, see chapter 11.1 • Anti-fog visor or anti-fog gel is applied to the inside of the suit visor, see chapter 11.6 • Anti-fog gel is applied to the outside of the mask visor • To wear undergarments suited for the situation, e.g. station wear or fire turn-out gear. If cold weather or risk of contact with cold chemicals, wear insulating underwear. Never use a suit which is not passing the pressure test or is damaged. 5.1 Donning Always have an...

Open the catalog to page 9
Chemical Protective Suits Instructions for Use TRELLCHEM ®  VPS FLASH - 10

6. In use During the intervention, make sure to: • Minimize the exposure to chemicals • Avoid direct contact with the chemicals as far as possible 6.1 Removal and reinsertion of hand from glove To check the manometer/pressure gauge, the hand has to be retracted from the glove: 1) Grab the right glove with your left hand 2) Pull the right hand into the suit 3) Check the manometer/radio/other 4) Put the right hand back into the glove again 5) To pull the left hand into the suit, instead grab the left glove with your right hand 6.2 Regulating the suit ventilation For suits fitted with a...

Open the catalog to page 10
Chemical Protective Suits Instructions for Use TRELLCHEM ®  VPS FLASH - 11

7.1 Initial decontamination After a response in hazardous environment, the suit must be decontaminated before taking it off, to protect the wearer from contamination. • Make sure to have an assistant for the decontamination. • The assistant also needs to wear suitable protective and possibly respiratory protection. • Rinse the suit with plenty of water, preferably with added detergent. 7.2 Taking off the suit After decontamination, take off the suit in reverse order of that described for donning above, and have someone assist you. 7.3 Final decontamination If the initial decontamination is...

Open the catalog to page 11
Chemical Protective Suits Instructions for Use TRELLCHEM ®  VPS FLASH - 12

8. Storage When stored the suit should be unfolded and inspected once a year, see chapter 9. 8.1 Storage conditions • Dry, humidity 50 ± 30% • Room temperature, 20 ± 5 °C • Away from direct sunlight • Away from ozone-generating sources, for example electrical engines, fluorescent lamps and air-conditioners 8.2 Storage methods The suit should be stored: • Folded as upon delivery or hanging • In the plastic bag delivered with it or in another tight bag or box • If stored in a soft bag, never store suits on top of each other, as too much weight or high pressure may damage the visor • If stored...

Open the catalog to page 12
Chemical Protective Suits Instructions for Use TRELLCHEM ®  VPS FLASH - 13

9.1 Maintenance schedule The specified intervals below are Ansell recommendations. Differing national guidelines must be complied with. For auxiliary equipment (SCBA, full-face mask, helmet etc.), refer to the respective Instructions for Use. For a list of spare parts & accessories, see chapter 11.6. Ansell Protects’

Open the catalog to page 13
Chemical Protective Suits Instructions for Use TRELLCHEM ®  VPS FLASH - 14

9.2 Visual inspection of suit The inspection shall consist of the following steps, see also chapter 9.1: • Visual inspection of both inside and outside. • Look for surface damages on material, seams, visor, inner and outer gloves. • Look for changes in the material properties such as brittleness, stiffness, swelling, stickiness or other phenomena which could be evidence of chemical degradation or aging. • Check function of zipper and zipper fitting. • Check function of the Bayonet glove ring system • Check the function of the exhaust valves and, if fitted, suit ventilation regulating valve/...

Open the catalog to page 14

All Ansell catalogs and technical brochures

Archived catalogs

  1. Tiger Paw®

    1 Pages

  2. Monostar 1

    1 Pages

  3. FIBERTUF®

    1 Pages

  4. AlphaTecTM

    2 Pages