
OPERATION AND MAINTENANCE MANUAL ANLIDAR INDUSTRIAL CO., LTD. http://www.anlidar.com
Open the catalog to page 1WARNING Important safety information enclosed. Read all these instructions before placing tool in service or operating this tool and saving these instructions. It is the responsibility of the employer to place the information in this manual into the hands of the operator. Failure to observe the following warnings could result in injury. When using electric tools, Basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury including the following: 1. Important Safety Instructions
Open the catalog to page 2WARNING! Read all instructions Failure to follow all instructions listed below may result in electric shock fire and/or serious injury. The term “power tool” in all of the warning listed below refer to your mains operated (corded) power tool or battery operated (cordless) power tool. a) Keep work area clean and well lit. Cluttered and dark areas invite accidents. b) Do not operate power tools in explosive atmosphere, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust of fumes. c) Keep children, and bystanders away while operating a...
Open the catalog to page 34) Power tool Use and Care a) Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. b) Do not use power tool if switch does not turn it on or off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. c) Disconnect the plug from the power source before making any adjustments, changing accessories, or storing the power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. d) Store idle power tools...
Open the catalog to page 4Operations Cautions 1. Please read the operating manual thoroughly and comply with safety regulation to operate this Multi-Function Controller. 2. Please grasp the plug of power cord while plugging in or out the plugs of connecting cord of Electric Screwdriver and power cord. 3. Please fix the power controller to avoid any danger of pulling and dragging the power cord. 4. Do not near oil, chemical materials or heated objects, also please be alert not to scratch the power cord by sharp object. 5. This type of Controller can only be applied to ANLIDAR Electric Screwdriver with Counter. Do not use...
Open the catalog to page 51. Use the controller voltage recommended in the specification of this manual. 2. When using a commercial power supply be sure to set up circuit and safety breakers. You must also properly ground the mechanisms. 3. The temperature and humidity should be kept at appropriate levels. 4. Do not set up the power supply in a room that has poor ventilation and where it may be exposed to dust and metallic flakes. 5. Do not put heavy object on top of power supply or pile thing on it. 6. Attach the power supply securely to a flat, stable surface. If the power supply is put a high place, take special care...
Open the catalog to page 61. The controller must be operated in top condition, one day working hour must be not more than eight hours. 2. Please note don’t let the controller get over heated, every minute use 10~15 screws to operate. 3. The frequency use of this electric screw driver is over eight hours a day, still it needs periodically testing and treatment. Every 5-6 months. 1. The use of other than genuine ANLIDAR replacement parts may Result in decreased tool performance and increased maintenance and may invalidate all warranties. 2. All repairs and maintenance of this tool and its word must be performed by an authorized...
Open the catalog to page 716 Pages
10 Pages
10 Pages
14 Pages
10 Pages
8 Pages
8 Pages
18 Pages
11 Pages
10 Pages
21 Pages
49 Pages
29 Pages
8 Pages
2 Pages
18 Pages
35 Pages
32 Pages